Leaderboard

I have always fancied one of these for a bit of fun. Let men know when you are bored of it I might take it off your hands if I haven’t scratched my SMG itch by then. (I’ll expect a message sometime next week 😂).....

Oh yes have to agree one I had to have in my collection too! Looks just like the Alpha tech grenade, had one but lost it, tried to get another one but apparently they got sued, I am all over this one though looks great!!

ive got some arriving today from firesupport, different brand, will pop in some of those silica bags i keep finding to assist with the moisture as well

Hi and welcome Christian, 6mm-ammo are a good brand. The non-bios work well for me and most others but some people have reported issues with them jamming their guns so it can depend on what gun you use. The problem with bios is they are hygroscopic meaning they absorb water even from the atmosphere. This can make them swell and jam when used. Yes, a gun can be damaged by BB's getting stuck or shattering inside. So you must keep them in a very dry place. They may still swell after some time and become unusable.

Wanted one for ages...sold a load of unused bits to fund it, but, well...

As I can't play airsoft right now, I might as well write about it... This time I share my thoughts on load bearing gear in airsoft, as I see people asking if they should use a chest rig or plate carrier all the time. I think load bearing equipment is very important, both from a practicality perspective and an aesthetic one. After all, airsoft is also very much about the dress up! https://www.impulse101.co.uk/post/plate-carrier-vs-chest-rig-my-thoughts-on-load-bearing-gear

Yes, keeping them in a sealed container/bag with lots of the silica gel is a good idea. (I always keep any sachets I get)

Sounds like a good plan. (I'd keep them next to the boiler or hot water tank closet) Yes, 6mm ammo is as good as any other known brand so you may as well buy some to try. If you're not happy with them then try a different brand.

Well yeah. Of course they will. But that's better than them being there for as long as a live, and then for everyone who lives here after me having to deal with them. I don't really care if I see them or not. Hi EDcase, Thanks for that, that's really helpful. I am currently using a G&G Arp-9 with a 11.1v Battery. I don't mind any performance issues, just so long as it doesn't cause permanent damage. I'm only using it casually for a bit of practise, so a few misfires here and there wont be an issue. I have a place set aside for them that's nice and dry, but I'm sure I'll use them up quite promptly. I imagine I'll get through them in a few days which hopefully wont allow them to turn. If you're confident that 6mm Ammo is a trusted brand, I'll take your word for it and order some today

TM Walther MPK.

Once in a while I am allowed to touch the jar. Only when I have been good though.

Excited to let you all meet the new Specna Arms Edge 2.0 H-Series!

So on inspection there was not only the sharp edges of the trigger guard wings but also a hefty burr from a knock it had taken. I cleaned up the burr with some fine wet&dry paper, de-greased the area and then masked it off ready. I used black Sugru to fill the gap and blend into the trigger guard wings and also around the scuffed area. I let it set over night and removed the tape then used a craft knife to tidy up the front where it had overlapped the tape. Feels great and you would not notice it unless you turned the gun over and squinted 😁

Oh dear what have I done. But still one of the prettiest guns I have laid eyes upon (Ares DSR1)

Haven't tried it yet but got the quake 8. Would of liked a trmr but we know that won't happen. Looking forward to using it

My new Tectonic Quake BFG and cylinder for Well MB12