Leaderboard

I got bored one night so took some "nice" pictures of my two primaries: If I'm playing outside then I'll stick a scope on the Recce. The little G&G Wasp tends to have my GoPro session Velcro'ed to the top of the rail (where the white bit is).

I am still in half a mind to buy it off you as I am too impatient to wait 10 - 20 days from HK I just think the ACR stock fits the SCAR nicer. Preferably the black version though as I do not want any multi tan/brown after having a G28

I have just bought a beautiful black WE SCAR H GBBR - the gun I have truly wanted all these years! However, I have never been a fan of the SCAR stock. I'm sure we all realise that it resembles a particular pair of footwear To fix this issue, I've purchased a SCAR to ACR stock adapter, with a black PTS ACR/Masada stock, which just so happens to also be my favourite stock! So I now essentially have my favourite rifle and stock combo. Now I just need to decide on optics... Leaning towards another Elcan SpectreDR to be honest.

It’s re-spawn for the grommets and re-gen for the crusty old f**kers !

No way?

so a little history first, i bought my CM16 2 years ago now, and its been a bloody good gun! it has never let me down. Above is the pic i took when i first bought the gun, below is how its been for the last year and abit (yes before anyone asks i did get my UKARA and do away with the green paint). 2 years on and out of warranty, i figured "i am going to hell ... whats another sin" so time for some modding!! before i began down this path i did a lot of thinking and tried to put together a plan of action of the 2 things that i wanted to achieve and my reasons. 1) improve trigger response - i play a lot of CQB and a quick trigger response is always nice To do this i have replaced the motor for a lonex a2 which i had laying around, massive improvement!! i have, but have not yet fitted a pico AAB mosfet, a speed adjustable trigger, 16awg wire and deans 2) shorten the barrel - Moving in a tight environment, while is not impossible, it is more difficult with a long gun. i actually contacted G&G and priced up a fire hawk top end ... for £30 - £40 more than there quote i could have bought a new gun!! - so i am not doing this So One i had got all the bits i figured i need, i began the strip down ... and ran into my first problem As you can see the bearing is dead ... opening it upon reviealed some more bad news Yeap that bearing is dead ... and the bevel bearing too, from my experience its normally the spur bearings that go first In any case i suspect the issue was caused because all/most of the grease has gone hard/crusty ... which is not good! Other then the bearings everything else looks ok, the gears look fine, the trigger contacts have minimal wear etc etc The piston has minimal wear, same goes for the piston head ... the spring needs a bearing guide .... and i may chuck that guarder sp100 spring i have laying around at it. (To be continued)