Leaderboard

I decided to stick on all my gear and take some more pics and a couple vids: https://imgur.com/a/GB4iy9Y (Damn I've put on some weight during lockdown, need the gyms to reopen)

so this un's a doozy.... and here's a strong argument for keeping access to expired ads.....

Just competed a case to house my game day pack, includes a dmr and pdw (barrel change drops gearbox to cqb fps). And the latest edition a hpa Crb, figure this will give me a setup for all site types and moods. All barrels r hopped 2 stock barrels prommy in the dmr with a Crb barrel and suppressor to shorten it for mobility without a range sacrifice. What ya reckon guys?

Republic of Korea Army Artillery Forward Observer concept loadout More gears are coming

A little covid DIY project for those who don't like rubber magpuls and want something more like these for your MWS stanag mags. You need: 3mm kydex, M3x10mm countersunk screws, saw / knife, heat gun, drill with 3mm - 5mm drills and countersink Cut the kydex into squares (I made mine 58x58mm) either using a saw or simply scoring it multiple times with a knife and snapping it Drill and countersink two holes along the center to match the screws on the base of the magazine. As the screws go into the mag at an angle it helps if you angle the countersink a bit too (as is done on the standard base plate) Unscrew the standard base plate but keep pressure on it, slide the kydex square over it, and secure both with the new longer M3 screws Heat the kydex square slowly with a heat gun, shielding the mag as much as possible (my mags all still seal afterwards... but this is is definitely not great for them) While hot, quickly tighten the screws a little more to help pull the kydex into the tabs on the base plate, then bend over the flaps. I got the tightest bend by pressing all three sides in with some wood scraps for about a minute, before then letting it cool completely with the main sides pressed in a vice... its a bit tricky to get a sharp 90 degree bend into 3mm kydex, but you can always re-heat if you're not happy with the first result Once cooled, unscrew and slide off the kydex again (keep pressure on the base plate and re-secure it with a screw...) to drill the hole for the gas fill valve. I tried drilling this hole at the start, but because the kydex warps when you heat and bend it I found it tricky to get the location right You end up with a nice 3mm ledge on the back and front of the mag which helps to get a grip on it, and the kydex adds some extra drop protection too. Not sure what the extra strain will do to the screws in the long term, but I don't imagine its that bad. Enjoy!

'Twas a reference to a thread a user made some time ago, he got roasted so hard I still have nightmares about it

Added a barrel extension with a Madbull OSS BPR2 over it for some long reach feeling. An LPVO might find its way on at some point. or shorter.