THE TM MWS thread

[Impulse]

57 minutes ago, JinxDuh said:

I got my MWS yesterday and filled it fine, got just over two mags out of the fill. Today using a different green gas (We 2x) and the gas spurts out of the fill valve instantly and I’m getting about 5 - 8 shots before the mag is empty. It’s being tested inside, same conditions as yesterday (But different gas). I’m assuming it’s the WE gas, so wondering what green gas everybody uses? 🤔

 

I'm using propane now, but if I was going to buy cans of green gas I'd go with the ASG ultrair (the brown cans).

[EvilMonkee]

27 minutes ago, JinxDuh said:

Cheers. I’ll give that a go! I tried a can of the nuprol (metal nozzle) and it seemed to gas fine too but only one mags worth before it was empty.

Make sure to purge the mags of air first.

[zizivert]

I wasted so much money to find the problem on my complete aftermerket MWS build. I finally replaced my G&P EMG steel trigger box by the GM (Guns Modify) steel trigger box and here am I, it works so well now.

 

On the G&P trigger box I used different lubricants, oil, ptfe, grease, different nozzle, different bolt carrier, different hammer springs with all the settings possible (100% to 180%), different fire selectors but nothing to do, same issues. The bolt carrier cycle look like weak (?!) as if the mag valve was not completely hit. Like the hammer didn't have enough power to hit it and also, with the fire selector at "semi" position, 75% of the time the mws was shooting on full.

 

After comparing the three trigger boxes (TM, GM and G&P) taking them apart to inspect everything, to check, to compare again, I still can't understand where the problem is coming from.