Jump to content

MP5K


Ricknin9
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

  • Supporters

Mmm, it does look tight, but if you're holding it close then your off-hand will be going around the drum at an angle, so I reckon you can make it work.  Worst case you could bin off the standard grip and put a tacticool one on there, like this one from PatrolBase.

 

The ACM Electric C-Mag for MP5 Series | Popular Airsoft: Welcome To The  Airsoft World Tokyo Marui MP5 400-Round AEG Drum Magazine – Airsoft Atlanta

Link to comment
Share on other sites

  • Supporters
8 hours ago, Rogerborg said:

 so I reckon you can make it work

 

the question is not can the question is should

 

and those questions have different answers.....

Link to comment
Share on other sites

Those rails look like the ones which came with my galaxy mp5k. They're a pain in the arse as you have to undo 7 screws to adjust the hop up, or disconnect the battery 

Link to comment
Share on other sites

  • Supporters
9 hours ago, Cannonfodder said:

Those rails look like the ones which came with my galaxy mp5k. They're a pain in the arse as you have to undo 7 screws to adjust the hop up, or disconnect the battery 

 

Oh, that is a real consideration, especially given that the hop ups on these like to go off unless you tighten the screws right up.

 

I'd recommend rear-wiring them though, there's room to run thick wiring behind the gearbox and up to the top tube - you can even squeeze a small mosfet into the tube along with a 7..4V lipo.

Link to comment
Share on other sites

Here is my TM MP5K, as you can see this cheap battleaxe one fits  However it does make it much less comfortable to use. I would just stick to hicaps.20210719_141127.thumb.jpg.f037ddbe2077200ef43a8fa078295eef.jpg

Link to comment
Share on other sites

1 hour ago, Mels said:

Here is my TM MP5K, as you can see this cheap battleaxe one fits  However it does make it much less comfortable to use. I would just stick to hicaps.20210719_141127.thumb.jpg.f037ddbe2077200ef43a8fa078295eef.jpg

 

Yeah, not my thing but I prefer the stubby mid caps so I'm probably the last person to be advising on this. If you want high capacity on an mp5k, I'd advise using the high cap double mag (560 BBs, but hard to carry multiple) or just multiple high caps (200 BBs each, but you can easily carry multiple).

Link to comment
Share on other sites

2 hours ago, Mels said:

Here is my TM MP5K, as you can see this cheap battleaxe one fits  However it does make it much less comfortable to use. I would just stick to hicaps.20210719_141127.thumb.jpg.f037ddbe2077200ef43a8fa078295eef.jpg

 

Horror Face GIFs | Tenor

 

That is a HPA line way from needing to be purified by holy fire 

 

For All of your Heresy Purging Needs (Warhammer Dump) - Album on Imgur

Link to comment
Share on other sites

That's like putting eagles wings on a sparrow. Taint natural! Lol

 

Link to comment
Share on other sites

If you're getting a drum, buy the manual g&g one.

1500 rounds, no battery or electronic board to faff about, feeds every single round.

 

*Actually* Reading your question, the g&g drum has a bit of a slant to it, you might not have enough clearance with the grip (unfortunately I don't have a mp5k to check if it clears)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...