Shootin Aces Posted June 29, 2021 Share Posted June 29, 2021 Hi all! I've not long purchased a Specna Arms SA-C19 Core, and have been upgrading it externally so far, I'm looking to change the crane stock to a ctr stock however this means changing the battery I use from a 9.6 Ni-Mh to a Lipo, however I'm a bit skeptical on changing the battery and if it is safe for the gun to run a lipo without damaging it, what would be the best suggestion? Thanks for reading, stay safe Link to comment Share on other sites More sharing options...
EDcase Posted June 29, 2021 Share Posted June 29, 2021 Running a 7.4v Li-Po is fine in an AEG. Look for the highest mAh that will fit. (this indicates how long it will last in a game) 1400 to 1600 should last a whole day with a mix of semi and auto use. Its also advisable to change the plugs to Deans (also known as T-connectors) They're small and make good solid connections. Link to comment Share on other sites More sharing options...
Shootin Aces Posted June 30, 2021 Author Share Posted June 30, 2021 9 hours ago, EDcase said: Running a 7.4v Li-Po is fine in an AEG. Look for the highest mAh that will fit. (this indicates how long it will last in a game) 1400 to 1600 should last a whole day with a mix of semi and auto use. Its also advisable to change the plugs to Deans (also known as T-connectors) They're small and make good solid connections. Thanks for the reply mate This is already wired to Deans so that's a bonus, I'll run it off a 7.4 and see how it performs with a few test shots Thanks again mate Link to comment Share on other sites More sharing options...
EDcase Posted June 30, 2021 Share Posted June 30, 2021 👍 Link to comment Share on other sites More sharing options...
rj1986 Posted June 30, 2021 Share Posted June 30, 2021 Rule of thumb is 1 mah = 1 shot. SO if you're a spray and prey, might want to get a 2nd. Link to comment Share on other sites More sharing options...
Speedbird_666 Posted June 30, 2021 Share Posted June 30, 2021 I always recommend 2 LiPos, so you can switch at lunchtime. Over-discharging can fatally damage them. If you are running the Core on the stock motor, you might not get the best performance with a 7.4v LiPo. I would add an SHS Hi-Torque Motor (or equivalent) to the 'must upgrade' list to give you a nicer trigger response and more reasonable ROF (14-15 RPS) on a 7.4v LiPo - that's the setup I typically use on my guns with 'stock' internals. Link to comment Share on other sites More sharing options...
EDcase Posted June 30, 2021 Share Posted June 30, 2021 Oh and you'll need a good intelligent charger. Search forum for discussion Link to comment Share on other sites More sharing options...
Supporters Rogerborg Posted July 5, 2021 Supporters Share Posted July 5, 2021 On 30/06/2021 at 15:12, EDcase said: Oh and you'll need a good intelligent charger. Search forum for discussion I was going to spoiler it and say SkyRC S65, but it looks like prices on them have just jumped up significantly. Even the basic SkyRC e450 is over £30 now. I hesitate to suggest the older technology iMax B6 models, but can we find the better ones for less? Link to comment Share on other sites More sharing options...
Supporters Lozart Posted July 5, 2021 Supporters Share Posted July 5, 2021 3 hours ago, Rogerborg said: I was going to spoiler it and say SkyRC S65, but it looks like prices on them have just jumped up significantly. Even the basic SkyRC e450 is over £30 now. I hesitate to suggest the older technology iMax B6 models, but can we find the better ones for less? https://hobbyking.com/en_us/accuell-s60-ac-charger-uk-plug.html?wrh_pdp=1&utm_source=google&utm_medium=cpc&utm_campaign=google_gb_shopping&countrycode=GB&gclid=Cj0KCQjw24qHBhCnARIsAPbdtlLl-CE4uNqggF55uvqaeXGHKdZHn2BVdzEHcyXS0T7celUyX3Cb5psaAs_9EALw_wcB&gclsrc=aw.ds&___store=en_us Basically the same ting in a different box. I have one and it works well. Link to comment Share on other sites More sharing options...
Speedbird_666 Posted July 5, 2021 Share Posted July 5, 2021 4 hours ago, Rogerborg said: I was going to spoiler it and say SkyRC S65, but it looks like prices on them have just jumped up significantly. Even the basic SkyRC e450 is over £30 now. I hesitate to suggest the older technology iMax B6 models, but can we find the better ones for less? Still £32 and in stock on HobbyRC: https://www.hobbyrc.co.uk/skyrc-s65-65w-6a-ac-balance-charger Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted July 5, 2021 Supporters Share Posted July 5, 2021 37 minutes ago, Speedbird_666 said: Still £32 and in stock on HobbyRC: https://www.hobbyrc.co.uk/skyrc-s65-65w-6a-ac-balance-charger and modelsport: https://www.modelsport.co.uk/product/skyrc-s65-ac-charger-65w-438918 Link to comment Share on other sites More sharing options...
Supporters Rogerborg Posted July 5, 2021 Supporters Share Posted July 5, 2021 All, right, I'm down, stop kicking. Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted July 5, 2021 Supporters Share Posted July 5, 2021 1 hour ago, Rogerborg said: All, right, I'm down, stop kicking. Link to comment Share on other sites More sharing options...
Skara Posted July 5, 2021 Share Posted July 5, 2021 You can run 11.1s on stock trigger contacts too. It takes an awful lot of time to wear/burn the trigger blades, by the time they need replacing you'll most likely have dumped the gun or upgraded to a mosfet of some sort. Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted July 5, 2021 Supporters Share Posted July 5, 2021 3 minutes ago, Skara said: You can run 11.1s on stock trigger contacts too. It takes an awful lot of time to wear/burn the trigger blades, by the time they need replacing you'll most likely have dumped the gun or upgraded to a mosfet of some sort. iirc think was about 6 months to burn out the f2000 primary contacts. but yes short term you can get away with, especially for a standard platform where new contacts can be easily got. however you need to pay very careful attention to not over-draining the batteries as that'll kill them, same applies for basic mosfets that don't have a cutoff. a lipo checker is your freind. Link to comment Share on other sites More sharing options...
Supporters Rogerborg Posted July 5, 2021 Supporters Share Posted July 5, 2021 3 hours ago, Adolf Hamster said: however you need to pay very careful attention to not over-draining the batteries as that'll kill them I hear this a lot, but I've got fat stacks of lipo batteries that have been drained flat, like <1V per cell, and recovered by giving them a quick boost by wiring them in parallel with a good cell, then knocking them up again by charging as lead-acid, then finally switched to lipo balance. The laptop I'm writing this on had its battery pack discharge to 1.2V, and that's an 11.1V pack with 3x3 18650 cells, so 0.4V per cell. I gave each 1x3 bank a blast, then 2x3, then finally across all 3x3. If you can read this, then it didn't explode and it still holds a decent charge. I do accept that it's bad for them, I'd avoid it possible, and I might just have been (consistently) lucky. Link to comment Share on other sites More sharing options...
Shamal Posted July 5, 2021 Share Posted July 5, 2021 4 minutes ago, Rogerborg said: I hear this a lot, but I've got fat stacks of lipo batteries that have been drained flat, like <1V per cell, and recovered by giving them a quick boost by wiring them in parallel with a good cell, then knocking them up again by charging as lead-acid, then finally switched to lipo balance. The laptop I'm writing this on had its battery pack discharge to 1.2V, and that's an 11.1V pack with 3x3 18650 cells, so 0.4V per cell. I gave each 1x3 bank a blast, then 2x3, then finally across all 3x3. If you can read this, then it didn't explode and it still holds a decent charge. I do accept that it's bad for them, I'd avoid it possible, and I might just have been (consistently) lucky. I've done similar with dead lipos by putting them on a nicad setting for few mins. Always stay with batt though and be ready to disconnect. But never had a problem. Regards Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted July 5, 2021 Supporters Share Posted July 5, 2021 15 minutes ago, Rogerborg said: I hear this a lot, but I've got fat stacks of lipo batteries that have been drained flat, like <1V per cell, and recovered by giving them a quick boost by wiring them in parallel with a good cell, then knocking them up again by charging as lead-acid, then finally switched to lipo balance. The laptop I'm writing this on had its battery pack discharge to 1.2V, and that's an 11.1V pack with 3x3 18650 cells, so 0.4V per cell. I gave each 1x3 bank a blast, then 2x3, then finally across all 3x3. If you can read this, then it didn't explode and it still holds a decent charge. I do accept that it's bad for them, I'd avoid it possible, and I might just have been (consistently) lucky. Whilst i accept its possible to do this, its one of those things that should be done on ones own volition whilst fully aware of the risks involved. I'm well aware lipo's are tougher than their internet rep would make them out to be, however its a case that dumb stuff we're happy to do ourselves we wouldnt always reccommend others do. For example in the case of reviving dead lipo's i'd ask if the £20 for a new battery is worth risking burning your house down. Link to comment Share on other sites More sharing options...
Skara Posted July 5, 2021 Share Posted July 5, 2021 For science, sometimes, it's worth sacrificing a building and all its occupants. Link to comment Share on other sites More sharing options...
Shamal Posted July 5, 2021 Share Posted July 5, 2021 11 minutes ago, Skara said: For science, sometimes, it's worth sacrificing a building and all its occupants. Or even a country. Now which one to start with lol Nagasaki has been done and hiroshima. Maybe something nearer. 😉 I know they are not countries but you get the idea. 🙂 Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted July 5, 2021 Supporters Share Posted July 5, 2021 22 minutes ago, Skara said: For science, sometimes, it's worth sacrificing a building and all its occupants. Yeah but if we doin that can we not do something cooler than a lipo fire? Link to comment Share on other sites More sharing options...
Shamal Posted July 5, 2021 Share Posted July 5, 2021 57 minutes ago, Adolf Hamster said: Yeah but if we doin that can we not do something cooler than a lipo fire? Gas? Nah that's been done. In the name of science of course 😉 Link to comment Share on other sites More sharing options...
Supporters Rogerborg Posted July 6, 2021 Supporters Share Posted July 6, 2021 13 hours ago, Adolf Hamster said: For example in the case of reviving dead lipo's i'd ask if the £20 for a new battery is worth risking burning your house down. Done in an explosion containment pie dish, low current, cells being touched and tested for heat, back door open, and ready to hurl the whole lot out there so it'll burn down my neighbour's house. Serves him right for building up to the property line. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.