Colin Allen

The compression on VFCs out of the box is usually awful, which could be a major part of the problem.

Before the AKs acquired mosfets, I used to do that with a small Allen key poked up the motor hole.

Isn't that what we usually do after a day's play with non-mosfet guns?

Either of the barrels would be an upgrade; the 6.02 is probably the best option. The yellow Macaron or MR Hop with AK2M4's red nub would be good options: https://www.ak2m4.co.uk/internal-parts/hop-up-buckings-nubs

From the flow chart, I cannot see a need to enter full auto to disable pre-cocking. However, it is not as simple as a Perun Hybrid or AB++, being typical of cheap Chinese mosfets. You have to reset the pre-cocking the next time you want to use the gun. I have the same hope, as I want to do a FIDF loadout.

https://www.ak2m4.co.uk/internal-parts/inner-barrels/xt-inner-barrel-aeg-601mm https://www.ak2m4.co.uk/internal-parts/inner-barrels/xt-inner-barrel-aeg-602mm

Sawflys are not pretreated; their anti-fog cloths work well, as do Cat Crap and Absolutely Clear. My eldest uses the latter for diving.

I would ditch the ZCI barrel and go for an XT one from @ak2m4; they are much better quality. I don't know much about the Friction Pro, so I am not sure how it compares with the Maple Leaf range.

That is very poor; what is the length of the inner barrel? Do you have a photo of the cylinder showing the window?

If there is a very slight leak, that is probably normal as the sealing of the ends may not be perfect. With the gun assembled and the nozzle fully forward, shine a light up the BB feed tube and look down the barrel; if you can see a ring of light, the nozzle is not sealing in the hop lips.

You need to remove the parts that go through the receiver.

I am not quite sure what you are asking with regard to the bolt catch; however, you cannot use a functional bolt catch with the Eon. You can either remove the lever from the current one or, if you do not still have it, get a replacement and modify it.

Not necessarily the voltage; maybe a higher capacity battery with a higher discharge rating.

A video would be useful so that we can listen to the screech. That would be a good starting point.

The lad has an Aster in his LCT Val; no issues.

I love Bifrosts; they make it so much easier to identify targets.

As a side comment, if you are having to use an M120 spring to get a decent power output, there is a serious compression/air seal issue. What capacity is the 7.4 (mAh)?

Hmm, I asked because I was wondering if the fin of the tappet plate could be slightly tight between the sector gear and the gearbox casing/bushing, causing it to be slow in moving forward; this could result in it being pulled back before it had time to move fully forward.

Did you reshim the gearbox?

The new site is terrible; the old one was better.

To be fair, that's a lot of potentially empty boxes.

Correct; the terrible CYMA mosfet does not use cycle detection.

I want you to make me an offer but I am not telling you what you are making an offer for.

The earliest use of it that I am aware of is from The Scourge of Corruption. Or a crafty Knaue needs no Broker. Printed for Henry Gosson and William Houlmes, 1615). However, that does not relate to juries. The earliest use of it relating to a jury that I am aware of is from The Muses looking-glasse. Printed by Leonard Lichfield for Francis Bowman, 1638), by the poet and playwright Thomas Randolph (1605-1635). If you have an earlier source, I would be fascinated to see it.

It seems that you need to restart the build.