Supporters Druid799 Posted July 7, 2019 Supporters Share Posted July 7, 2019 Right then I have a couple of TM recoils that have been around the block a good few times (socom/G36/74su and a sopmod) and I’ve started to notice the motors are not quite as good as they were , gearboxes are fine but the motors are definitely in there twilight yrs now . So simple question Gentleman suggestions for good affordable replacement motors for these fine work horses of mine . Link to comment Share on other sites More sharing options...
Asomodai Posted July 7, 2019 Share Posted July 7, 2019 If you are sticking with the same gears go for an SHS/Rocket Green. 16TPA version. Otherwise, I have a new TM EG1000 in my JG MP5 and it goes like stink. Maybe pick up a replacement for your current one? They can be had cheaply second hand if you wait for one to come up. Link to comment Share on other sites More sharing options...
Iceni Posted July 7, 2019 Share Posted July 7, 2019 There is something you can try... And I repeat try. There is no guarantee this will work for you, and I don't recommend it (but it does work if done right). Take the motors out and make a test loom. Flick switch, Wire, Connectors. Then run those motors in a glass of deionised water till the water goes black, Dump the water and do it all over again till the water starts to come out reasonably clear. Re-lube the bearings top and bottom, Put on some new brushes if needed. This will clear the crud out of them, All the carbon and brush deposits that get into the bearings, magnets and caps. Afterwards, you'll either have dead motors, or ones that run like new. Just be sure to allow the motors to fully dry before you install them back in the guns, and lube again before they go back in. Most of the supermarkets sell the water you need for about 60p a litre.https://groceries.asda.com/product/car-maintenance/carplan-deionised-water/479358 Link to comment Share on other sites More sharing options...
ak2m4 Posted July 9, 2019 Share Posted July 9, 2019 Second what @Iceni says, give it a clean. There's some decent video's on YT as well. I even fixed the wife's expensive hair dryer motor just wiping the carbon / crud off the brushes and actuator Link to comment Share on other sites More sharing options...
Supporters Rogerborg Posted July 9, 2019 Supporters Share Posted July 9, 2019 I always keep a couple of litres of isopropanol / isopropyl alcohol around for cleaning electrics. Dunk, or get in there with a small brush. Link to comment Share on other sites More sharing options...
Supporters Druid799 Posted July 9, 2019 Author Supporters Share Posted July 9, 2019 Cheers guys after getting the advice from players Who’s opinions can be trusted (well I think can just about be trusted anyway !😉) the ‘dipping’ is the the way I shall be going , watch this space .👍 Link to comment Share on other sites More sharing options...
Musica Posted July 10, 2019 Share Posted July 10, 2019 21 hours ago, Rogerborg said: I always keep a couple of litres of isopropanol / isopropyl alcohol around for cleaning electrics. Dunk, or get in there with a small brush. I spilled coke on my mechanical keyboard took it apart soaked the PCB in isopropyl for a day scrubbed some of it with a tooth brush lightly and it was revived! Use it for cleaning battery terminals after a leaky battery too. Thermal paste remover too. Link to comment Share on other sites More sharing options...
.gif.c9becc9e80e8b91706ea684ec6e23c92.gif)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.