All Activity
- Past hour
-
As another option, some green gas pistols can work in winter too - non blow backs like the MK23 (if you can stand the firm and mushy trigger), or those that have little recoiling mass - like the AAP. If you have struggled with GBB pistols in the winter but haven’t yet tried an AAP, that might be worth a try. I run mine on MAPP gas in the winter, and as a secondary, it's been spot on down to zero degrees and a little below. Caveated to say - that's use as a secondary - i.e. 5 quick shots every now and then to get me out of trouble when people are in my MED. I suspect use as a primary in the dead of winter, it would still be sub par.
-
Carhartt hoodie(fleece inside), 3 Tactical wear, total 65GBP with post
Survivor20211 posted an advert in Gear
.thumb.jpg.ee4dcf451320b6af580c6a6ec9471d03.jpg)
Time Left: 6 days and 23 hours
- For sale
- As new
1. Carhartt hoodie(with fleece inside) Size: M 170cm ; 2. G3 tactical pants(Black) Size: M 30 170cm ; 3. G4 combat hooded(Range green) Size: M 30 170cm ; 4. G4 tactical pants(Range green) Size: M 30 170cm ( 5. free you one tac bag)All Brand New!! 65GBP with post. (Recommended height is 170cm but you can't be too thin")£65
- GB
-
Looks like it to me too. Take it slow and methodical to get the M14 apart, and take an especial note of how the fake bolt mechanism comes apart/goes back together as you do it - M14s can be a bit frustrating, and to swap the Hop out, there is a fair bit of disassembly to do. Worth the effort though, just take a few photos as you take it apart as an aide memoir (assuming you haven’t done it before of course!).
-
Need Some Advice – Struggling to Maintain My MWS Setup
Hobbnob replied to Ulmocuk's topic in General Discussion
O rings can be easy to replace but getting the size right can be a frustrating initial cost. For standard TM MWS mags, I use m4 x 1 and M12 x 1.5. For the nozzle, which brand of nozzle did you replace it with? Some brands like angry gun have a higher failure rate than average, but it can also be caused by loading the magazines to max capacity which then puts upward pressure on the nozzle, leading it to come into battery at an incorrect angle and break -
Colin Allen reacted to a post in a topic:
SSE 18 worth it?
-
Old? What an understatement, some have weeds growing out of them!
- Today
-
What gun and NPAS is it? Do you mean set up or install? For setting up, with a chrono it takes probably 10 mins to set the NPAS and hop probably about the same.
-
The general consensus is that AEPs are dogshit and a waste of money, poor performance and horrendous trigger response. Better off with a CO2 pistol, work all year round, largely unaffected by cooldown, etc. This was recommended to me by @Colin Allen and he was absolutely spot on, and i've only used CO2 pistols since. I have Umarex/VFC Glock CO2 mags i run in my other Glock GBBs without issue. Going by the SSE18 i'm guessing you're fine with Glocks, so worth a look. (I put the CO2 mags in my 18c and the full-auto is fast.) Also have an Umarex/KWC CO2 H&K USP, which is really nice but all proprietry inside which mostly rules out upgrades.
-
STAG joined the community -
I think the word is eclectic. Which is good, all for it.
-
TheFull9 reacted to a post in a topic:
Knobhead🤦♂️
-
TheFull9 reacted to a post in a topic:
Knobhead🤦♂️
-
Is that not the bottom of the hop unit? https://www.sixmm.com/en-gb/products/cyma-g36-hop-up-chamber-setfor-tokyo-marui-m14-aeg-series?srsltid=AfmBOoo_DgxJqB2FDvqr_tgwTo5vwLuZijEMPz8amFEh1_G2Xd_f51pm
-
hunter511 reacted to a post in a topic:
WE M9 gen1/2
-
Anonymoose reacted to a post in a topic:
Invicta Woodland site to shut down.
-
Time Left: 6 days and 21 hours
- For sale
- Used
Starting from top to bottom. Asg cz p09 green gas newish, used once £13 WE glock 17 green gas sold Kjw hi capa green gas £10 Nuprol raven G17 co2 sold Nuprol raven G17 extemded co2 £18 Nuprol raven G17 co2 sold Kjw hi capa green gas no base plate £9 Kjw hi capa co2 £10 Kjw hi capa co2 £10 WE M9 chrome leaky £8 Postage £3£15
- GB
-
Time Left: 6 days and 21 hours
- For sale
- Used
Here is a Mancraft SDIK. Regulator has a slight leak where the brass screw is. Collection only. Sutton-in-Ashfield NG17£100
-
Time Left: 6 days and 21 hours
- For sale
- Used
This is a boneyard g&g m14 that I originally got as a box of bits. I've attempted to reassemble it but the video I was using a a reference skipped the bit where you add the selector switch, so those bits are still loose but included. There are a couple of other bits I missed as you'll see from the last photo. It is missing it's front sight but everything else I think is there. (sixmm.com have a cyma front sight in stock that may fit). The externals are in very good condition. The major issue with this is the motor cage is damaged. 2 of the 4 curly bits that grip onto the gearbox are snapped halfway down. You can still push the motor cage onto the gearbox it doesn't grip it firmly. The gearbox cycles fine if you hold everything in place. It's wired to mini tamiya. There's no mag either. It comes with a replacement new motor cage. Feel free to ask questions. I'm after £80 including postage and fees You need ukara or valid defence to buy this please.£80
-
Alfie reed joined the community -
Time Left: 6 days and 21 hours
- For sale
- As new
Adjustable tactical vest (with shotgun shell panels and mp5 pouches attached) Tactical Belt Hydro Pouch Single point molle sling Knee Pads Cap, Mask and Mesh Goggles Assorted admin, radio and mag pouches Universal Holster £10 posted or collection.£60
-
Galvatron reacted to a post in a topic:
custom gbb
-
Galvatron reacted to a post in a topic:
custom gbb
-
Time Left: 6 days and 17 hours
- For sale
- Used
Glock 19x Gas Pistol. Very little use, practically in brand new condition. Comes with box and instructions/manual. Any questions feel free to message me. Add £13 for tracked shipping.£90
Aylesbury - GB
- Yesterday
-
I've got one you can hire in Crowborough 🤷
-
.thumb.jpg.af85768e93b474d47044c899f63c0f81.jpg)
Time Left: 6 days and 13 hours
- For sale or swap
- Used
Serviced and Built to sell ; Full re-wire rewired to deans 325-330 fps (1.02j) with hop set for .28g Brand New Parts; XT low profile solid bushings Rocket m100 spring Zci poly hop unit, Maple Leaf Macaron 60 rubber XT omega nub ZCI Full Stock Rail covers - 2x hi cap mags Sling £155 Collected £170 Posted Any questions feel free to ask£155
Doncaster, South Yorkshire - GB
-
Took advantage of the good weather to take stock of the armoury so far. A fairly good mix of new with (very) old, classic with quirky.
-
Chev Chelios reacted to a post in a topic:
Gel blaster RIFs - what's up with those?
-
Are they classed as using "fraggable" projectiles like Paintball guns I wonder, but would being able to fire full auto negate that or cane they point to other types of gun ref projectile size. Could also fire projectile's other than Paintballs so not sure about that point. As you say the hole thing is just PR and until it benefits nobody cares. The rules on Airsoft guns are silly when anyone over the age of 18 can rock up and buy an Air Gun that looks 100% like an Airsoft Gun or just buy an IF and spray it. I just thank God Hazel Blears got fucked off or we would all be speed softers right now
-
Was looking into getting an SSE18 for winter as GBB pistols just don't really work for me in winter. just wanted to get some advice before i drop a chunk of change on it and all the other bits and bobs. i usually run a sniper so it would definitely be useful but idk if there is another better option. any advice is appreciated
-
Time Left: 6 days and 12 hours
- For sale
- Used
Saudi grey choc chip set. Shirt size: fits like a large/short Trousers size: 36 reg £100 (including shipping and fees)£100
- GB
-
Liam.k14567 joined the community -
navyvet86 reacted to an advert:
WA Wilson Combat 1911
-
I'm looking for a replacement for the inner magwell as the feed tube is broken but I can't seem to find what I'm looking for, does anyone know what it's called or the part number?
