Ares striker AS-01 long range issue

[hairyballs]

Hi,

 

My striker is fully upgraded but it's sending BB's after about 60m to the left, I'm using .48s which is bang on putting rounds into the same target again and again butt the aim off is about 4 to 5 feet.

 

Any help would be great.

[Skara]

On 09/05/2022 at 20:01, hairyballs said:

fully upgraded

Maybe that's the issue.

 

Care to write down a parts list?

 

Maybe your hop rubber is slightly tilted or the TDC isn't applying proper pressure.

[hairyballs]

The upgrades are

Maple leaf MR 70 bucking

Maple leaf Omega nub

Teflon cyinder

AA hop up unit 

Lycan Romeo Sear 

Jaeger Precision Hagane AS01 Trigger - Heat Treated 

AED feed tube

6.01mm 550mm thigh bore barrel

Airsoft Pro Upgrade set for Ares Amoeba Striker with M150 spring. 

Upgrade set for Ares Amoeba Striker spring action rifle. The package contains the basic parts to increase the performance.

 

Hybrid Piston:

 

Fully lightweight aluminum body (lighter than upgrade piston from Ares)

Two polyacetal (POM) rings with lubricating groove for good slip in the cylinder.

Stainless steel piston catch.

Rubber front pad. The impacts of the piston are so quieter and the impact is spread over a larger area.

Back pressure head improove sealing due to six air channels.

Spring guide:

 

Made of stainless steel on CNC machines

Equipped with a ball bearing to reduce spring tension when compressed.

 

Spring:

 

M150 Tempered steel spring Included. 

 

 

 

[Skara]

So they go straight up to 60m then veer left?

Or does the BB gradually move along its path?

 

 

Edited May 12 by Skara

[Tackle]

It's an easy fix, you just need to rotate your bb's 90° degrees when loading.

Simples🦧

[hairyballs]

The BB goes straight then veers to the left.

2 minutes ago, Tackle said:

It's an easy fix, you just need to rotate your bb's 90° degrees when loading.

Simples🦧

I will give that a go 🤣🤣🤣🤣🤣🤣

[Samurai]

If it's not that two diameter cylinder, like the edgi, then there's nowhere near enough air volume for a 0.48g BB and an 550 barrel.

70 hardness rubber is too hard for that weight. The recommended hardnesses are for the measured FPS on the weight you use, not the FPS it would be on 0.20g.