Sam Pascoe Posted August 29, 2017 Share Posted August 29, 2017 How do I remove the muzzle of my G&G CM16 SRXL? I can not see a pin which is holding it on. Link to comment Share on other sites More sharing options...
AndyGif290368 Posted August 29, 2017 Share Posted August 29, 2017 Have you tried turning it in the other direction in case they done away with the pin and put a ccw thread instead. Other than that it looks like a lot of the vids push the pin up from inside the muzzle brake. Link to comment Share on other sites More sharing options...
RR01 Posted August 29, 2017 Share Posted August 29, 2017 A lot of the G&G CM16 guns have a moulded flash hider integral with the outer barrel and cannot be removed. Link to comment Share on other sites More sharing options...
Supporters Lozart Posted August 29, 2017 Supporters Share Posted August 29, 2017 You'll need to remove the handguard to get at the pin: Link to comment Share on other sites More sharing options...
BenBurnside Posted August 29, 2017 Share Posted August 29, 2017 I have the same gun, and the thread is ccw, I did not have to access a pin I just used a pair of pliers and twisted it with them, in the left direction hope this helps. Link to comment Share on other sites More sharing options...
Sam Pascoe Posted August 31, 2017 Author Share Posted August 31, 2017 Cheers guys, will be trying it out tonight Link to comment Share on other sites More sharing options...
Sam Pascoe Posted September 1, 2017 Author Share Posted September 1, 2017 All done, cheers everyone Link to comment Share on other sites More sharing options...
GeneralRaam Posted April 9, 2018 Share Posted April 9, 2018 Did it just unscrew in the end? Was there any screws that needed removing prior? Just having the same trouble with mine Link to comment Share on other sites More sharing options...
Supporters Rogerborg Posted April 12, 2018 Supporters Share Posted April 12, 2018 We need closure on this anecdote! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.