Jump to content

Yuukan

Members
  • Posts

    19
  • Joined

  • Last visited

  • Feedback

    0%

Profile Information

  • Guns
    Primary: TM CQB-R, A&K 60
    Secondary: TM HI-Capa, TM M870 Breacher
  • Loadouts
    Lumber - Tac
  • Sites
    UCAP Bunker
    UCAP Greenops
    Ambush Southampton
  • Gender
    Male
  • Location
    Petersfield

Recent Profile Visitors

2,819 profile views

Yuukan's Achievements

  1. Has anyone found a full length mlok optic mount ? Hoping to have a way to mount my light pressure switch on to the top of the MP5.
  2. Do I have it twisted ? Does the Warhead brushless motor also include a mosfet ? I just wanted to stick in a brushless motor to improve efficiency, silence some of the whirr to give me more clack clack and have a little more torque for pulling a heavier spring.
  3. Has anyone tried running a standard speed warhead motor yet?
  4. Sooo are these Magazines ready yet ?
  5. strykerles is farming ranks :P

    1. strykerles

      strykerles

      jumped from 9 to 12 overnight :D

  6. By any chance have you experimented with sticking a small tracer unit in there ?
  7. What optic mount are you using and does it sit level ?
  8. Can anyone suggest a suppressor that would fit the small acetech tracer inside of it ?
  9. Would you consider £80 for both ?
  10. Yuukan

    TM M4 Recoil parts

    Can I grab the front sight post and delta ring off you !
  11. What is the size of the mask ?
  12. I’d happily take this if it’s not already spoken for.
  13. So just wondering. Is it just the Steel upgraded cylinder I should go pick up, and should I also replace the stock piston at the same time? Are the Lycan 90 degree sears the ones to go for? If I replace the bolt and sear should that allow it to pull the bolt with alot less force or is it still a hard bolt pull even with the upgraded bolt? Does the upgraded steel bolt run around ~£80 ?
  14. Can someone help me with my Striker. Its an AS01, I've gotten it off a friend of mine as he didn't get on with it. The thing feels like I'm dragging a small piano back as I have to use some serious elbow grease to pull the bolt back. I've tried silicon oil and greasing the gun which made no noticeable difference. I've tried the stock spring and an M130 and found that the bolt pull is extremely tough. Between him and Me we've both put less than 100 bbs through it. I'm just not sure what needs to be replaced or done to correct this, I've also noticed the plastic "sleeve" that the bolt moves fore and back in also seems to slip back a little bit before moving forward. The Plastic sleeve surrounding the bolt looks a little bit gnarled up on the bottom near the pin from the sear. After looking at the photos I'd love an opinion, can I get this working smoothly with some sanding, do I need to get a new bolt/upgraded bolt, replace the piston with an upgraded one or do I just throw my hands up and throw money at a different gun ?
×
×
  • Create New...