Are 11.1s correct for my gun after the work that has been done to it???

[Wegalaxy]

Hello,

 

So I own a ARP 9.

Here is a list of all the new parts that it has over the past year.

 

Converted to deans

Gate aster

Quantum trigger

friction pro hop rubber

 

So recently I have had a new gear set put in as the stock g&g one packed it in.

 

I believe it was a 18/1 gear ratio.

 

I have had a 14/1 hi speed gear set installed. (still with stock motor).

 

It shoots 25 RPS and shoots 307 fps on .25s.

 

I will be shooting in binary and semi only and this gun sees heavy use as it is my only AEG.

 

So here is my question.

 

Should I continue to use the 11.1s or down grade to 7.4s even to the gun shoots and operates fine?

 

As I hear people saying 11.1s will damage my gun with the new 14/1 gears.

 

But I have 5x 11.1 1,100 mah batteys and it would be expensive to replace.

 

Looking forward to hearing you opinions as I wont the most life out of my gun.

 

Thanks.

 

 

 

 

 

 

 

Edited 11 hours ago by Wegalaxy

[Airsoftt]

11.1v is going to put more strain on the gun and potentially make it break faster.

 

If you want the best trigger response: 11.1V

If you want to try to prolong the life of your RIF: 7.4V

 

You've put a fair amount of upgrades into it, and its your only RIF so I would say go for 7.4v. Or potentially buy another RIF as a backup for when you need to repair your primary.

[Austeyr]

You absolutely can run an 11.1v, the aster will take care of the majority of it.