Marui 18c, Fire Select Stuck

[Mels]

Hi guys,

 

I've just changed the slide on my 18c. Everything was fine until I put the selector switch back in. Now its stuck on single fire. Does anyone have any suggestions?

[Cr0-Magnon]

Arrgggh, I would struggle to explain it but I've just rebuilt one of these and it is very fiddly to get right. You're best watching a Youtube vid on it and following step by step.

[Mels]

The trouble I'm facing now is that I can't seem to move it at all, even too remove it. I was hoping I've missed something obvious. 

[L3wisD]

@rocketdogbert? Have you come across this on your billions of Glock rebuilds? ?

[Guest]

@L3wisD Hate the bloody things, try not to touch G18’s anymore ??.

 

As has been said, check out a few vids, try to dislodge the selector ??‍♂️

[Mels]

Thanks guys, ill check out a few more videos and try to figure out what its stuck on.

[proffrink]

From what I recall from my times fucking with Marui glocks, check you've not lost the tiny spring that goes in the selector itself. If the spring is crimped that can cause a lot of issues, and this happened to me a few times on reassembly. Basically take it apart and put it back together again is worth a go most of the time anyway.

[Cr0-Magnon]

Sounds like you positioned the selector incorrectly and the little pin bit is pushing out in the wrong place. See if you can locate it and push it back a bit to allow you to rotate.

[Mels]

Hi guys,

 

Thanks for the help and advice with some small modifications to the nub im back in business.

 

Thanks again.