Barny Posted August 24, 2020 Share Posted August 24, 2020 Is there a way of adding more velcro to cummerbund so that I can tighten it down more? I was wondering if there was a panel of molle backed velcro that will make up the difference as the flap that folds down over them is only held on in one small corner. When pulling the mags out I nearly undo the velcro too! Link to comment Share on other sites More sharing options...
Smiling-Dutchman Posted August 24, 2020 Share Posted August 24, 2020 Do you mean something like this? https://milspecmonkey.com/store/pouches-panels/819-msm-large-patch-panel.html Link to comment Share on other sites More sharing options...
hitmanNo2 Posted August 24, 2020 Share Posted August 24, 2020 You need to adjust the cummerbund at the back of the PC to pull in each end so there's reduced overlap and proper Velcro contact. Link to comment Share on other sites More sharing options...
Barny Posted August 24, 2020 Author Share Posted August 24, 2020 1 hour ago, hitmanNo2 said: You need to adjust the cummerbund at the back of the PC to pull in each end so there's reduced overlap and proper Velcro contact. Agreed, but my skinny frame means the overlap wont engage with the fold down flap fully, so say only a third is secure and then not evenly. When tugging on a fast mag i'm peeling the edges up which means the mag doesnt dis-engage until that slack is taken up. Its not a quick, clean, FAST release. The panel that Smiling-Dutchman suggested could possible work. Its a bit large and i could possibly need two. Its certainly given me a suggestion to search for. Thanks both for your help 😎 Link to comment Share on other sites More sharing options...
Barny Posted August 24, 2020 Author Share Posted August 24, 2020 I think these will do it.... https://www.vipertacticalshop.co.uk/viper-adjuster-panels-x-2.html Link to comment Share on other sites More sharing options...
Enid_Puceflange Posted August 24, 2020 Share Posted August 24, 2020 Do what I did Eat more, move less 👍 it’ll happen naturally 😂 Link to comment Share on other sites More sharing options...
Moderators Tackle Posted August 24, 2020 Moderators Share Posted August 24, 2020 2 minutes ago, Enid_Puceflange said: Do what I did Eat more, move less 👍 it’ll happen naturally 😂 Worked for me 🐷 Link to comment Share on other sites More sharing options...
Barny Posted August 26, 2020 Author Share Posted August 26, 2020 On 24/08/2020 at 23:00, Barny said: I think these will do it.... https://www.vipertacticalshop.co.uk/viper-adjuster-panels-x-2.html Arrived today and do the job perfectly 😎 Link to comment Share on other sites More sharing options...
Supporters TheFull9 Posted August 29, 2020 Supporters Share Posted August 29, 2020 The actual problem here is you bought a PC/cummerbund that's much too big. Adjustment should primarily be done in the back as well (as mentioned), especially with a PC that uses the classic velcro-up-front closure. It's much better to overlap the bund in the back, even lace it up with paracord, chop it down etc vs what you've done which obviously does the job on a basic level but adds a lot of needless bulk and complexity up front where you don't want it. I don't know what the PC is to advise any further than that. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.