heroshark Posted November 8, 2019 Share Posted November 8, 2019 7 minutes ago, Adolf Hamster said: might be tempted to try that, although stock efficiency is fine for my needs (ie can it fire 1 full stack of bb's and lock back before recharge) as a general rule outside of hop tweakery i tend to leave my gbb's alone, it's a finely balanced system and i've learned the hard way that if you screw with them too much it can be very hard to recover. Nice thing about both these is it only makes better use of the gas its already putting out. The route gives the gas in a better flow through than the standard tm one less angles on the inner face. The lpe shims give a better seal between the route and bbu and can be adjusted by the amount you use. Basically you get about a 10-15fps boost and more consistency. 5 minutes ago, Adolf Hamster said: i'm running an autobot in the hicapa and the makarov both with i keys. hadron fang works nice too. Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted November 8, 2019 Supporters Share Posted November 8, 2019 5 minutes ago, heroshark said: Nice thing about both these is it only makes better use of the gas its already putting out. The route gives the gas in a better flow through than the standard tm one less angles on the inner face. The lpe shims give a better seal between the route and bbu and can be adjusted by the amount you use. Basically you get about a 10-15fps boost and more consistency. fair enough, might give them a look. i did consider a while back trying that for the makarov as it really needs an effeciency boost but sadly i can't find any for that magazine. Link to comment Share on other sites More sharing options...
heroshark Posted November 8, 2019 Share Posted November 8, 2019 15 minutes ago, Adolf Hamster said: fair enough, might give them a look. i did consider a while back trying that for the makarov as it really needs an effeciency boost but sadly i can't find any for that magazine. Can mark up some thin plastic and make your own with a good sharp knife. Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted November 8, 2019 Supporters Share Posted November 8, 2019 Just now, heroshark said: Can mark up some thin plastic and make your own with a good sharp knife. for shims? not a bad idea actually. Link to comment Share on other sites More sharing options...
heroshark Posted November 8, 2019 Share Posted November 8, 2019 Aye Link to comment Share on other sites More sharing options...
Musica Posted November 8, 2019 Share Posted November 8, 2019 47 minutes ago, heroshark said: Aye what does the shim do? 1 hour ago, Adolf Hamster said: i'm running an autobot in the hicapa and the makarov both with i keys. what is an i key? Link to comment Share on other sites More sharing options...
Supporters Adolf Hamster Posted November 8, 2019 Supporters Share Posted November 8, 2019 9 minutes ago, Musica said: what is an i key? it's a little metal peice goes under the hop arm on a pistol, kind of the pistol equivalent of a flat nub for an aeg. Link to comment Share on other sites More sharing options...
heroshark Posted November 8, 2019 Share Posted November 8, 2019 1 hour ago, Musica said: what does the shim do? Raises the route to give a better seal against the bbu. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.