Jump to content
Updated Classifieds rule 5 - Adverts must include your username and date in photos

KWA Kriss Vector Owners Club

Nasro

By Nasro,
in Gas Guns

 Share
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

  • Replies 552
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Codenamebald
Codenamebald

New toy. First play this weekend  Weather permitting 

Davegolf
Davegolf

Yes for an AEG a spring change is the energy source and most common method, especially if you need to drop a decent amount of FPS e.g. 30. For a drop of 5-15 you can trim the spring, e.g. cut off

DarkAssassin
DarkAssassin

KWA Kriss. With 4 X 50rd mags hpa tapped. Also have a hpa drum but its a little wide and uncomfortable to use naturally.   Also got the .45 osprey suppressor and an eotech 553 sight.  

Nasro Community Regular

Nasro

Posted
  • Author
Posted
  On 22/02/2018 at 20:36, sniperslucky said:

Hi,

 

can you advise if a P90 magazine holder would suit the vector mags?

 

thanks

 

Wayne

Expand  

 

I have been told it can, But you’d want to use a bungee cord to hold it down rather than the mag pouch flap.

Link to comment
Share on other sites
sniperslucky Community Regular

sniperslucky

Posted
Posted
  On 03/03/2018 at 00:06, rocketdogbert said:

Well, it works. Prototype so doesn’t look amazingly pretty, but I now have 1400 rounds to play with ha ha ha

 

5d66cEd.jpg

 

W6MSqia.jpg

 

Expand  

Looks good enough to me, did you get the vector rear wired when you changed the stock over to the M4 type?

Link to comment
Share on other sites
Guest

Guest

Posted
Posted
  On 03/03/2018 at 12:32, sniperslucky said:

Looks good enough to me, did you get the vector rear wired when you changed the stock over to the M4 type?

Expand  

 

Cheers. And no, haven’t bothered, I get a decent enough battery for my uses. Would be very easy to do though

Link to comment
Share on other sites
Monkey-Trumpets Rookie

Monkey-Trumpets

Posted
Posted

Hi Guys, got my KWA Vector a few months ago but didnt use it due to cold weather, Getting it ready for the spring/summer games and notice its shooting 240-260FPS max. Iv changed the hop rubber and given it some general maintenance, but no change, iv even put a power up Suppresor on it and it doesnt get above 260FPS. I know these new were 350-380, both myself and my local gun tech cant think what to do next, any suggestions?

 

Also rocketdogbert where did you get your UBR stocks? cant find them anywhere

Link to comment
Share on other sites
Nasro Community Regular

Nasro

Posted
  • Author
Posted
  On 08/03/2018 at 19:33, Monkey-Trumpets said:

Hi Guys, got my KWA Vector a few months ago but didnt use it due to cold weather, Getting it ready for the spring/summer games and notice its shooting 240-260FPS max. Iv changed the hop rubber and given it some general maintenance, but no change, iv even put a power up Suppresor on it and it doesnt get above 260FPS. I know these new were 350-380, both myself and my local gun tech cant think what to do next, any suggestions?

 

Also rocketdogbert where did you get your UBR stocks? cant find them anywhere

Expand  

 

Im not sure what the tech has seen/done but a few things to look into would be around the bolt carrier and piston. 

 

1) Check your piston spring, maybe that’s has gone weak. Pull the nozzle out and let it go and it should retract back very fast and solid.

2) when you pull the piston nozzle from the bolt, check the sides and give it a light grease if it has dried out.

3) inside the lower receiver slide where the bolt carrier is inserted near where the bolt moves forward and back when fired should be lightly greased. 

 

Something else to check, find out from previous owner if an Npas has been installed, or you’ll need to open the piston and see. If there is one... you’ll need to close it fully for full power. 

 

I’ll show some pictures tomorrow when I get home. 

 

Let me know now if you’ve done any of these checks above 

 

mabs

Link to comment
Share on other sites
Whompa73 Collaborator

Whompa73

Posted
Posted

Didnt know this was here. I verry recently aquired a KWA vector in original box and near enough unused condition . Guess by the look of it that its possably had less than 5 to 10 mags through it in its life. 1 of them by me and i have to admit its absolutly sweet to shoot verry possably the nicest thig i have ever shot. Question is do i run it or not with it being like new?

Link to comment
Share on other sites
Guest

Guest

Posted
Posted
  On 09/03/2018 at 01:27, Whompa73 said:

Didnt know this was here. I verry recently aquired a KWA vector in original box and near enough unused condition . Guess by the look of it that its possably had less than 5 to 10 mags through it in its life. 1 of them by me and i have to admit its absolutly sweet to shoot verry possably the nicest thig i have ever shot. Question is do i run it or not with it being like new?

Expand  

 

Use it at least once and see how it feels ;)

Link to comment
Share on other sites
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...