Hellfish

Casual Urban Operator. I need a Drop leg for my sidearm as it's far too uncomfortable on my belt and gets in the way of stuff.

Cheap RIS Forend from the Classifieds and some LaRue style index clips for my Specna M4

Added a cheap RIS Front End from the Classifieds, some LaRue style index clips and an AFG2 foregrip to finish it off.

Been faffing with my load bearing gear for the past few months trying to get it just right ..... nearly there I think! Started as a bog standard Viper Spec Ops Chest Rig but I kinda wanted it to be a bit more high speed/low drag/tacticool ....so I ditched the bungee retention for the mags and bunged some 5.56 retention inserts in there with added velcro glued to them, and inside the pouches for added security. Then the the 3 pistol/torch pouches that sat on the front were removed. In place of the torch pouch on the right hand side, I've attached a TQ holder with TQ, sharpie and medical shears. On the left hand side I've adapted an old holster panel and now the knife is attached directly to the rig on the outside of the radio pouch. Finally I used fabric glue to add some velcro on the rear so the dangler can be used Bit of fancy bling in the shape of a dummy flashbang and some speedcuffs and I'm pretty happy with it. Next thing is to increase carrying capacity for additional stuff such as water, jacket, food etc so a small molle pack will be added on the harness straps (not pictured)

Old bits of pouch, paracord and some time to kill = Knife Dangler to go along with the variety of (pretty basic) modifications I'm doing to my Viper Spec Ops Chest Rig to make it a little more "mine". Its a bit rough and ready and this may yet evolve into something better looking, but as for now ....

Is that good? Sounds a bit BDSM 🤔 😁

WIP ... Lightweight Recce Loadout : VIPER Sepc Ops Chest Rig with added shoulder pads and Scrote Pouch. Pistol is secure in the rig and I'll be getting some 5.56 inserts to replace the current bungee retention. Comms will fit into one of the utility pouches to either the left or right hand side of the rig. I need some Kneepads and I'll be using a better belt than the one I'm wearing in the pic, but otherwise the rig is comfortable, has a decent amount of storage which can be increased with the addition of a daypack, keeps all the bits and bobs snug and secure and leaves your hips etc free of encumbrance.

We F226 with Full Trades. It's chunky and delicious!

We P226 with full trades from the Classifieds on here.

Changed scope mount to give better sight clearance over the DBAL and added a Lancer Tactical Magwell.

It's nowt special, but it's mine and I like it .....

My kit will be considered fairly generic but is comfortable and functional

Currently faffing about trying to recreate My in game Modern Warfare AKS74u .... not 100%, but I'm pretty happy otherwise

There are adapters that fit on full stock receivers ; I had one on an old AK74 I used to have. I'm not a huge fan of the folding stock tubes; always seem to retain a wobble .... however I shall look into the above. Thanks fellas.

I'm looking to swap the folding stock for a buffer tube/AR Stock set up Its been a fair while since I tech'd anything .... Can anyone confirm if this will fit the AKS74U? https://www.patrolbase.co.uk/cyma-metal-body-for-ak47