Jump to content

Motor Height Adjustment Screw.


This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

Do people thread lock theirs, leave without or use PTFE tape?

Link to comment
Share on other sites

A bit of thread lock holds it👍

I have lost one before because they can sometimes unscrew with vibrations.

Link to comment
Share on other sites

Cheers guys.

 

Does anyone else take ages listening out for the slightest variation when adjusting it? 😬

Link to comment
Share on other sites

Shouldn't take more than a minute really, as you dial it up (as the motor gets lifted up) it should gradually sound better and better until you hit the wall where it gets too tight which will be obvious, when you meet the wall, just go back a bit to where it last sounded best, trust your feeling

 

In my head it is roughly like this:

 

spacer.png

Link to comment
Share on other sites

Posted (edited)

That's the idea but you have to have pinion height above the bevel gear set correctly too otherwise the noise is not related to the meshing but rubbing on the bevel shaft or always being unmeshed.

This why is can never seem to change much or finding the sweet spot is Impossible sometimes 

Edited by Sewdhull
Link to comment
Share on other sites

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...