Not DMR Posted June 25, 2021 Share Posted June 25, 2021 Hi,I have a KWA Ronin T10, and i would like to replace the original handguard with a MK18 Ris handguard, that comes with a delta ring that is different from the one that is fitted on my Ronin. The problem is, i can’t remove the KWA Delta Ring, no matter what i do. I’ve tried blowing it with my heat gun and torquing it, i have also tried WD-40, i even dented the upper receiver because of the torque applied and it just won’t come lose. I am attaching pictures so you all can see it. If you guys could please recommend me a solution, i would really appreciate it. Link to comment Share on other sites More sharing options...
Supporters Lozart Posted June 25, 2021 Supporters Share Posted June 25, 2021 Seems KWA get the Hulk to tighten their barrel nut Sounds like brute force and ignorance is the order of the day! Link to comment Share on other sites More sharing options...
alxndrhll Posted June 25, 2021 Share Posted June 25, 2021 Either heating it up or putting it in the freezer for a while may/will likely help. Given the design of the barrel nut I’d put a suitably chunky Allen key (or similar) in one of the holes on the barrel nut and start tapping said Allen key around with a hammer/mallet. An AR block would help but I’ll go ahead and assume you don’t have one. Link to comment Share on other sites More sharing options...
ak2m4 Posted June 25, 2021 Share Posted June 25, 2021 Ideally you'll need something called an AR vise, it's used to clamp the receiver in place. If KWA do use glue then a blow-torch to heat the barrel nut (not Delta ring) will help. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.