Hop up question

[ronin677]

Hi guys

 

Could anyone tell me what this 'pin' is on a G&G hop up unit (see pic)

 

 

My GR16 is only firing about 100ft before the bb's curve to the ground. The hop up doesn't seem to alter the spin on the round at all. I've replaced the hop up rubber and cleaned the barrel but it makes zero difference

 

any advice?

[Monty]

Have you checked to see if the nub is missing?

[M_P]

It's to hold the hop arm in place.

 

And yeah as monty suggests, check the nub is still there and that it's assembled properly.

[ronin677]

haha ok I have just researched how to maintain a hop up unit

 

here is my repaired hop up unit and yes the nub was there (but i replaced it with a new one anyway). I will test it again tomorrow and see if there is any difference.

 

I'm suspecting the barrel was upside down and so the nub was not able to deform the bucking rubber (thats what I'm hoping). I let you all know

 

 

btw are there meant to be any o ring seal on the hop up?

[jcheeseright]

nope, no need for any o-rings, the rubber should fit well enough that it's self sealing.

[Lozart]

Some guns have O rings placed along the barrel to centre it. These usually end up getting pushed up to the front end of the hop up unit as you put the barrel in.

[ronin677]

Some guns have O rings placed along the barrel to centre it. These usually end up getting pushed up to the front end of the hop up unit as you put the barrel in.

ahhhh I found one of these and couldn't for the life of me figure out what it was for because it was near the hop up. Being nearer the end of the barrel makes perfect sense

[ronin677]

ok so i tested it tonight. It instantly fires further than before with the hop up adjust as low as it will go. I then added hop up and it seemed to get slightly worse with less distance until the hop up was almost fully wound up, then the bb's were firing out drastically to the left before arcing back to the right!!!! I thought they arced upwards with lots of back spin

 

anyone??????

 

the barrel is mounted correctly with the cut out of the barrel against the hop up nub

[ronin677]

hahahaha

 

ok so 1 day later and all is fine.

 

I took the rife to pieces again, checked out the entire hop up and meticulously put it back together again. It fires like a dream now