-
Posts
8,508 -
Joined
-
Last visited
-
Days Won
416 -
Feedback
0%
Rogerborg's Achievements
Single Status Update
-
Torp quatily mortor arivvad!
- Show previous comments 2 more
-
Phew - you got the M140
THIS is a decent-ish motaaaaaaaaaa
it is on par with a SHS HT there abouts
not too insane - not mega amp draw
and doesn't run very very warm, that is burns out quick
(like the insanely fast M160 BD)
The 140 is a torquey motor with grunt but not insane shit
the 160 is like the SHS High Speed - quick as fuck
but will run very very warm/hot and drain battery quickly
plus it runs so warm/hot, the 160 will heat up lots when going nutz
and bearings in the can will crap out, end bell gets hot & bearing loosens
basically the 160 will just tear itself apart if you start to cane it
& what you will be left with is just the neodym magnets
& unlikely to use the say 14tpa armature much from the 40k+ motaaa
the 140 is probably about a 17/18tpa likely a 25k to 28k
it is a cheap motaaa, with them tabs at the end
rather than the SHS/G&G lock ring type
D pinon - was a slightly bit different to SHS pinion
seems to mesh slightly better with Cyma std pinions
Now they might have changed spec slightly over the years
(likely)
But If anybody remembers Airsoft Peak & TinyWind (snigger)
in Hong Kong knocking these out really cheap with offers/vouchers
I bought a couple of 140's and half a dozen 160's
(plus a few shit m120 ferrite ones - yeah avoid)
wish i bought all m140's and avoided the 160's & 120's
imho - the 140 is the best one in the Big Dragon range
so you made a wise choice I reckon with a balanced motor as they say
The M120 has ferrite magnets & a blue motor tower
The M140 has neodym magnets & a red motor tower
The M160 has neodym magnets & a gold motor tower
D type pinion that meshes nicely or slightly better with some other bevels like Cyma stock bevels I found
avoid the M120 = G&P clone
the 140 & 160 are about same price
go with m140 over the 160 is you want it to last properly
A SHS HT will be easier to service though
but the M140 type you could drop a diode across it to reduce contact arcing without needing a mosfet straight away
so horses for courses as they say
m140 is a good motor upgrade for stock gun without needing to rip it all out and rewire with mosfet but use a diode
DON'T INSTALL A DIODE IN A G&G OR SHS !!!!
it will short out - but is safe in a TAB type motor
and does reduce arcing/spikes
-
it is alright - it has some grunt
perhaps not quite as quick as a SHS HT @ 30k tops
but deffo 25k maybe a bit more
you could just slap that in a cheapo Cyma m4
maybe a diode and just run it for some added zest on the cheap
and it will serve you well, last a good while
and when all said & done you can gut it and use the neodym magnets
for another motor rebuild when it all croaks
but won't tear itself to bits like the M160 does whilst draining your battery like a gold digging GF
- Show next comments 3 more