novioman

I did check the valve it was installed fine. As I said above, sent it back and asked the shop their views on the problems, no answer, just refunded me.

Thanks for that, I didn’t know about this issue.

Exactly, sent it back in the end, don’t know if it’s a common fault on these, I did ask the shop but they just refunded without answering.

I was hoping someone might have the same pistol and offer advice.

No interest so won’t bother to get more than 1

Just bought one of the VFC made Sig 320 x carry. Nice pistol, one concern if you put a gassed up mag in the pistol when the gun hasn’t been cocked the mag valve is obviously making contact with the valve knocker as the pistol firers, not powerfully, but another for the slide to move forward and back very quickly, just like when you lower the hammer on a gassed up mag. Cant find out if this is a faulty pistol or just how this one is designed.

Going to be acquiring some Sig Air red dot pistol sights, these are extremely hard to get hold of, any interest so I can judge how many to order. Cost will be around the £65 mark. Designed to fit the Sig M17/18/320 pistols, complete with fitting plates and tools etc.

Managed to get another guarder one but had to buy the nozzle, blowback housing as well. Did find a couple of Marui ones which were delivered today. I am told Marui have changed the design to be stronger, but these 2 look exactly the same as the guarder ones.

Told, but I have no reason to doubt him, but this is going back several years so they have probably improved a lot since his findings.

Do bio bb’s still make your barrels dirty, I know they use to.

If the mags gassed o.k, have a look at the nozzle, would advise taking the slide off, is their anything in the nozzle, part of a bb or something.

My Marui based Sig 226E2 went down last weekend. Had it apart today to try and sort it. Found the guarder enhanced nozzle valve was in 2 pieces. Disappointing as this pistol is only used with abbey ultra gas, not the most powerful of green gases as we know. It’s also had very limited use, only firing 300 to 400 bb’s. Is this a common breakage, I have glued the 2 parts back together, seems o.k, anyone else done this, did it last. Any recommendations for stronger nozzle innards. I thought being a guarder upgrade part it would be good.

It won’t, becomes very unreliable as the nozzle doesn’t retract.

I saw this, but it doesn’t have the end cap.

Having trouble finding the above. Does anyone know if the spring is the same as the M&P9 or the Hi Capa.