taroslice Posted November 14, 2011 Posted November 14, 2011 I've had a terrible wobble on my G&P m4 and been told happens to alot of their m4's? Tried getting it prepared but the only option the guy gave me was to super glue it together...and i wasn't too keen on it. So i've thought about conversion kits... But from my view is it just removing all the internals of my m4 and move it into another gun? Cause to me...all airsoft guns are basically the same internally, its more going for the LOOK of the gun.
taroslice Posted November 19, 2011 Author Posted November 19, 2011 Were the lower and upper receiver join.
Supporters M_P Posted November 19, 2011 Supporters Posted November 19, 2011 Look for an accuwedge, that might help Or, put a rubber o-ring around the bit on the upper receiver that Is it a gbbr?the pin goes through (if you know what I mean?) If not say and ill get a picture
taroslice Posted November 21, 2011 Author Posted November 21, 2011 Would one of these bad boys would prob help?? http://shop.ehobbyasia.com/accessories/pin...metal-body.html
Supporters Nutster Posted November 21, 2011 Supporters Posted November 21, 2011 G&P's are known for the gap between receiver halves, though I've never known them to wobble
BaggyPants Posted November 21, 2011 Posted November 21, 2011 I had a Dboys M4 some time ago with a similar problem. The solution was a gasket made from thin black card, which was fixed with double sided tape to the lower receiver. Worked like a charm The receiver on my G&P Magpul doesn't appear to have this problem at all. It's nice and tight.
Supporters M_P Posted November 21, 2011 Supporters Posted November 21, 2011 Would one of these bad boys would prob help?? http://shop.ehobbyasia.com/accessories/pin...metal-body.html Might do but its made for gbbr's
Recommended Posts
Archived
This topic is now archived and is closed to further replies.