Wolverine Inferno Gen 2 Inconsistent FPS

[JVacation]

Hello, 

 

I recently installed a Wolverine Inferno Gen 2.

 

Currently running a ZCI 6.02 tightbore barrel and a ML yellow.

 

My issue is that I don't believe my FPS is as consistent as it "should" be.

 

I just chronoed and I am getting

 

322.3

319.6

316.4

313.2

321.3

320.7

319.9

318.3

319.2

 

When I put paper over the mag feeding tube the paper does launch up a little bit.

 

Has anyone get any ideas?

[snuff]

Installed into what?Go on FB the wolverine owners group.

[JVacation]

2 hours ago, snuff said:

Installed into what?Go on FB the wolverine owners group.

Installed into a SSR4. Have applied to join the group but haven't been accepted yet.

 

Cheers

[snuff]

Could it be an alignment issue,seems to be a pretty comon area for concern.

[Steveocee]

SSR4 so a VFC body? They are usually pretty good for HPA conversion but absolutely I'd be looking at alignment. 

Line out - batery off > Shine a light into your magwell and then look down your barrel, should see a perfect halo, if not, you need to adjust the alignment.

Sometimes a slight toe upwards is acceptable but once alignment is right you should be good.

 

That or your nozzle isn't sealing too well in your bucking which would be abnormal as the ML's tend to have marginally longer lips so seal better.

[Cr0-Magnon]

On 08/02/2023 at 19:22, Steveocee said:

SSR4 so a VFC body?

 

SSR4 receiver is the same used by Lancer Tactical, Specna, Evolution etc..

It's the SSR15 which was made by VFC.

[Steveocee]

4 hours ago, Cr0-Magnon said:

 

SSR4 receiver is the same used by Lancer Tactical, Specna, Evolution etc..

It's the SSR15 which was made by VFC.

 

They bought out another one? Genuinely can't keep up lol

[Cr0-Magnon]

1 hour ago, Steveocee said:

 

They bought out another one? Genuinely can't keep up lol

 

Yep and discontinued the VFC one, haha.