Jump to content

Screw cut outer barrels


emilianoksa
This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and possibly forgotten) topic.

Recommended Posts

Just about all rifles seem to come with an external screw cut outer barrel for attachments. Some have flash hiders etc.

 

Is there any standardisation of diameter and pitch? I notice that there are 16mm to 14mm adaptors on the market.

 

I just wondered if most barrels were 16mm and attachments had 14mm internal threads. 

 

Or is there a lot of variation?

Link to comment
Share on other sites

  • Supporters

Most AEG barrels are 14mm CCW threaded. A lot of AK's however come with a 22mm CW or 16mm thread. The 22mm ones are usually on the outer of the flash hider and can be removed to reveal a 14mm CCW thread. G&P tend to use a 14mm CW thread though.

 

Some (like the CZ Scorpion I believe) have a 16mm thread, my old MP5K has an odd thread but it's actually an internal thread on the sight post rather than on the barrel as such.

 

Adaptors are many and varied though!

Link to comment
Share on other sites

10 minutes ago, emilianoksa said:

Thanks for clearing that up for me.

 

On a related subject does adding the extra weight of a silencer, or tracer unit to a blowback pistol running on green gas, make it difficult to impossible for the slide to work properly?.

 

Silencers fit to the barrel, not the slide sir.

Link to comment
Share on other sites

Guest scalawag
8 minutes ago, emilianoksa said:

Thanks for clearing that up for me.

 

On a related subject does adding the extra weight of a silencer, or tracer unit to a blowback pistol running on green gas, make it difficult to impossible for the slide to work properly?.

No it makes no difference to the operation of the slide.  The suppressor or tracer unit will screw into the barrel on most pistols, and as the slide moves independent of the barrel it is not affected.  The barrel may move/drop  a little bit when the gun is fired but this movement is also not restricted by the addition of a suppressor/tracer.

Link to comment
Share on other sites

Thanks.

 

Yes, I am new to airsoft, but not to guns in general. I know the silencer is attached to the barrel.

 

Just wondered if the extra weight on the barrel might increase the inertia of the slide due to the front heavy balance. Some gbbs don't have a particularly heavy recoil.

 

Thanks for also clearing that up for me.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...