Jump to content

Archived

This topic is now archived and is closed to further replies.

airsoftwarrior147

ris troubles

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and probably forgotten) topic.

Recommended Posts

hi recently brought myself an ris fro my ics m4 unfortunatly it didnt fit it was about 2cm to long and i was wondering other than buying new barrels and inner barrels is there a way of moving the front sight so that the hadguard is longer.

if its any help the ris looks to be the same as the we 0056

thanks joe

Share this post


Link to post
Share on other sites

Get a low profile gas block and a free floating rail.
Ics make their guns with out of spec size gaps between the handguard cap/ front sight and the delta ring.

 

Or an ICS branded one, that'll fit too.

Share this post


Link to post
Share on other sites

There is a grub screw underneath the front sight post on ICS m4's, loosen it up with the correct size allen kek and you should be able to move it to fit the ris.

Share this post


Link to post
Share on other sites

×
×
  • Create New...