mini-airsoft-dude Posted December 24, 2012 Share Posted December 24, 2012 the standerd battery it comes with is a 8.4 1600mah and alot of people said they dont last long so is there a better one to use that wont brake the gun ? Link to comment Share on other sites More sharing options...
Supporters Richard65 Posted December 24, 2012 Supporters Share Posted December 24, 2012 Easiest solution is to buy a spare battery and swop them over at the lunch break (cost about £13). You can also buy higher capacity batteries which last longer e.g. 8.4v 3300mah. Many forum users like the component shop (link below) http://www.component-shop.co.uk/html/8_4v_airsoft.html Link to comment Share on other sites More sharing options...
Supporters M_P Posted December 24, 2012 Supporters Share Posted December 24, 2012 To be honest unless you fire a ridiculous amount or something one of those should do fine for a day- though I definitely suggest getting a spare just in case, it's better to be safe than sorry. Link to comment Share on other sites More sharing options...
CES_williamson Posted December 24, 2012 Share Posted December 24, 2012 this battery is a good one but they run out after a while so buy a spare but to be sure i would buy 2 more to have 3 overall just in case there is a problem with one of the battery's this is a mini connector battery too make sure you dont buy any male large connectors because these wont fit your gun unless you buy a converter wire which are very cheap. Link to comment Share on other sites More sharing options...
mini-airsoft-dude Posted December 24, 2012 Author Share Posted December 24, 2012 ok thanks Link to comment Share on other sites More sharing options...
Tariq Posted December 24, 2012 Share Posted December 24, 2012 I run 8.4V 1600mAh batteries in my g36 and they last me at least 2 days of skirmishing before flat... Just get a spare and it will do. As to bigger batteries... they won't fit in the handguard remember Mini type batteries (mini nunchuck are better) or go LiPo or LiFe Link to comment Share on other sites More sharing options...
Saltyyy Posted December 25, 2012 Share Posted December 25, 2012 Go 9.6V, you'll get a better ROF When you have some experience go over to LiPo's, a 7.4V will do you fine, don't go 11.1V unless you have a Mosfet installed that will help cover trigger contacts. LiPo's will give you better response time and ROF. Also, switch over to deans if you can for better response, for a £2 and 10 minutes of soldering job, it's well worth it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.