two_zero Posted November 8, 2012 Posted November 8, 2012 Hello, had a sick idea for a m4 trigger guard.. thinking maybe either just for my own use or maybe I have say 100 pieces made.. anyway, anyone knows the measurements, or maybe even have a manufacturing drawing? would it been draw with imperial or metrics? Also would the real steel version have the same measurements as a G&P / most airsoft guns? P.S. even just the exact measurement between the holes as well as the exact hole size would be to a lot of help.
Supporters M_P Posted November 8, 2012 Supporters Posted November 8, 2012 I will probably be able to check this tomorrow evening for you, will reply again if no one else has by then
two_zero Posted November 11, 2012 Author Posted November 11, 2012 I will probably be able to check this tomorrow evening for you, will reply again if no one else has by then would be excellent mate!
Supporters M_P Posted November 11, 2012 Supporters Posted November 11, 2012 Sorry never got round to it,gimme a couple of hours to wake up properly and I'll do it
Supporters M_P Posted November 11, 2012 Supporters Posted November 11, 2012 I only had a ruler so its not gonna be amazingly precise, but form the end of one hole to the other is 4.7cm I couldn't measure the diameter of them due to the ruler not being precise enough but hopefully that'll at least help a little.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.