DestrO
-
Posts
96 -
Joined
-
Last visited
-
Feedback
100%
Content Type
Profiles
Forums
Buy a Patch
Classifieds
Posts posted by DestrO
-
-
On 08/12/2021 at 08:14, BigStew said:
It requires more force to compress a stiffer spring so unless you up the pressure it will slow the the gun cycle rate. Anyway point being with out using a higher pressure gas a metal slide will reduce performance and using a higher pressure gas will run a greater risk of the gun breaking.
If the OP wants a metal slide Guarder is the cheapest you should go and no after market metal slides, even the high end stuff is drop in. They all require modification to fit right.
only just seen your reply, all it would do is slightly up gas consumption no? not slow down actual cyclic rate.
-
48 minutes ago, BigStew said:
just don't you'll make it perform worse. it will cycle slower due to weight and the additional force required to over come a stiffer spring.
a stiffer spring isnt going to increase cycle time
-
did you buy the rail new? i think they all come with an aeg nut as new
-
On 03/10/2020 at 20:25, MadMole said:
I've fired about 15,000 Valkyries now, 0.28 and 0.25's. Not a single issue, very consistent.
I have a personal set of data on many makes BB's where I measure mass, size in 3 axis, molding marks, blemishes and internal voids and Valkyrie are very very good in all aspects I've measured. Personally I have swapped to Valkyrie for all but heavy BB's for which I use Novritsch's. I also would use Geoffs and G&G's. Valkyrie are bringing out heavy BB's shortly so I suspect they will be my sole provider then
Brands I avoid, Blasters (horrible random internal voids), Baddass, Snow Wolf, Cursed, draft club (airsoft operators box (boy are they bad!))
Hell, even cheapo Bulldogs are better than blasters (and much cheaper)
bulldogs are the worst BB you can use lmao.
-
NGRS rifles require NGRS specific mags or an adapter
-
how much are you planning to retail them for?
Am I the ass hole?
in General Discussion
Posted
i do find ironic:
when charging the buyer the fees is against paypals ToS...