The gun comes without a mag and is not functioning. The slide is cracked at the back and stained, the frame is very shiny but intact. All of the internals are included - everything from the frame and the slide.

I have left them fitted for convenience but the trigger unit and/or trigger bar will need looking at again. Some of the pins have been replaced and there is a brand new Guarder slide stop lever and spring installed. There are also one or two bits that I either replaced or bought and didn't use which I will put in a little bag. The slide will need to be removed with a bit of wiggling and force, or I could remove it for you if you prefer. 

History: in case you are wondering.

I have a complete set of internals for the TM Glock 19 Gen 3.

It's a long embarrassing story but I tried to put the TM frame internals into a Guarder frame. I have done this before with Guarder Glock 17 Gen 2 and 4 frames and encountered little or no difficulty. However the Glock 19 frame was anything but a straight fit. When I finally got them in, the slide stuck and I had to hammer it off. I tried again - first removing material from the inside of the frame and trying the slide again  - and again and again and again, finally damaging the Guarder frame and breaking the TM slide. In the end I gave up, put the parts in a box  and sold the magazine.

So what I have now is a complete set of internal parts including bbu, outer and inner barrel, front and rear sights etc - everything except a slide, frame and magazine. I still have the original Marui frame which has a slight mark next to one of the assembly pin holes that you would probably not notice.

. The slide is cracked at the back and stained, and needs to be replaced and  the frame is very shiny but intact. All of the internals are included - everything from the frame and the slide. I have left them fitted for convenience but the trigger unit and/or trigger bar will need looking at again. Some of the pins have been replaced and there is a brand new Guarder slide stop lever and spring installed. There are also one or two bits that I either replaced or bought and didn't use which I will put in a little bag. The slide will need to be removed with a bit of wiggling and force, or I could remove it for you if you prefer.

Please note: this gun does not work but it has all the parts. When it was working I only ever test fired it before attempting to change the frame. The nozzle return spring is bent and will need replacing, and as far as I know it is the only part that does. But I am not an expert and there are no guarantees with this gun. 

However I think 30 pounds for a complete set of TM internals is a fair deal, for anyone looking for spare parts etc, and I am sure that a more talented tinkerer than me could get it to work. Comes in the original box with owners manual.

Since it is technically still a rif, I will need UKARA from prospective buyers. 

5 pounds extra for postage