Make: A&K
Gun/Model: STW M4 Recoil Engine 2018
Accessories: Full list below
Condition: Excellent
FPS: 340 (2nd cylinder with original 420 Spring)
Splits/Swaps/Part Exchange: No/No/No
Price/Payment: £650 listed items Posted. Buyer pays fee's
Pictures: Always

NOTE: Can include all listed in the tarted up picture (Scope, PEQ, M3X) but its then £775.

Removed all extras so this is so you can pick up the gun and use with spare mags.
 

Hello, So I have a really annoying of habit of building a full RIF setup only to not use the damn thing or I find something else. Anyway, this is a tarted up STW (Clone PTW) with a bunch of extras. A few things to note however first:

1. The STW/PTW system does not allow the correct fitting of Nuprol MK18 rail systems so this was dremelled down to fit flush against the upper receiver.

2. Do NOT snap open the RIF like you see fools doing in youtube videos or you will most likely shatter or at the least damage the upper receiver front pin section, at the worst both the upper and lower. Just firmly open it like it should be (Including PTW's)
3. Gun was put together, then sprayed immediately with Nuprol Coyote Brown and Sand colour with a mesh/skin effect. I mention this even though there are pictures because while its painted it has not been used.
4. It has NOT been skirmished. It has fired approximately 120 rounds in order to make sure the motor, cylinders, batteries and gearbox are functioning correctly. Never been skirmished. Listed as used because its sprayed.

5. Nearly ALL PTW (Check on dedicated PTW/Real Steel forums) have a small amount of wobble in receiver because of the design. Dont be alarmed.

Room to expand, Just simply get yourself a new upper for about 20 quid and build a CQB ready.

Accessories Included are:

2x 11.1v LIPO Batteries (1300MaH x2)
1x Pinty Red Dot Reflex Sight
1x Vertical Foregrip
1x Nuprol MK18 12.5 RIS
1x Original M4 RIS
3x Magpul PTW PTS  Mid Cap Magazines (Tan)
1x A&K CTW Mid Cap

2x Cylinders + Spring (Fitted is 320-340, other is 400+)
1x Unfitted G&K Rear Sling Mount + AABB Front Sling Mount
1x PTW Speedloader


Room to expand, Just simply get yourself a new upper for about 20 quid and build a CQB ready. You just need to put in a new spring for the spare cylinder