The Aug Trigger (Q)

[srjv00]

Do you guys know of any AUGs with normal triggers? Or at least an AUG that could be modded to have a fire mode selector?

The gun is so hot, but the two stage trigger really sucks imo, and it's disallowed in some CQB arenas. Thank you ♥️

[Iceni]

You can modify the safe bar to have a semi only position. It requires a knife and some marking out, but is a fairly easy modification if you are a competent adult.
 

Quote

I'm going to start to write the cut guide for the safe bar.

There might be a couple of edits as I make this post.


This is to give an aug a Semi only mode, without removing full auto.


First you want to remove the safe bar. It just pushes out to either side.

Once out there is a small metal clip that you need to keep safe.

Look on the back side of the bar, It should have a red dot on it. There should also be 2 grooves cut into this side of the bar. You need to cut a third groove between those existing slots. I find a small triangular file works best for this. You want to try match the existing grooves for depth and width as well as keeping the cut straight.




Once the cut is done you put the bar back into the gun (red dot to the shooter). Make sure you get the metal clip in position first before you put the bar in. And once it's back together you should find the safety now has 3 click positions.

Split the upper from the lower if you haven't already done so.

Now you need to measure the travel on the trigger to the semi position.

Grab a marking tool. Pen scalpel it doesn't matter. Set the bar to the safe position and pull the trigger so it stops. Mark this position on the side of the trigger slide. (1)

Pull the trigger until it reaches the de-tent where the semi auto shot finishes mark it off (2).

Pull the trigger all the way into the full auto position until it stops mark the position(3).


Measure between 1 and 2. Transfer that to the safe bar using the front of it as the 1 position. Measurement (B)




You now need to take a sideways measurement.

Put the safe bar in the auto position.

Pull the trigger all the way in. And push the safe bar over towards the safe setting till it stops moving. Use the side of the gun and mark this position on the safe bar.

Release the trigger, and push the safe bar to the new middle position. Mark the safe bar on the same side.

The distance between these marks is the amount of material you need to remove from the bar (A).




Mark the cube that needs cutting and remove it down to the lower level of the bar.

The cube of material that remains will act as a stop for the trigger, so do not accidentally cut it off! Working slowly with a scalpel is better than trying to go at it with a big knife, saw or dremel.




This should give you a semi only position on an Aug, You may have to refine the cuts, but removing less and working up to the correct measurement is better than removing more.

 

 

[Asomodai]

7 hours ago, srjv00 said:

Do you guys know of any AUGs with normal triggers? Or at least an AUG that could be modded to have a fire mode selector?

The gun is so hot, but the two stage trigger really sucks imo, and it's disallowed in some CQB arenas. Thank you ♥️

 

Tokyo Marui Aug High Cycle has a fire mode selector.