dagga333 Posted November 10, 2017 Share Posted November 10, 2017 Has anybody fitted an airlab sorbo pad to an octarms? Also which part it glued to the piston head, black or white? Link to comment Share on other sites More sharing options...
Davegolf Posted November 10, 2017 Share Posted November 10, 2017 Technically you're supposed to glue the sorbo part to the cylinder head and the white (plastic?) part faces the piston head. Personally I remove the original rubber buffer from the cylinder head (if you are using a single piece cylinder head) and then glue the sorbo directly to the cylinder head. Further to that I cut the white bit off completely too, I find it gives a nicer AOE / piston / sector mesh usually Link to comment Share on other sites More sharing options...
johnnyj Posted November 13, 2017 Share Posted November 13, 2017 The White part of the kit is to stop the pad its self disintegrating , I have always fitted direct to the cylinder head with its rubber pad removed and adjusted the thickness of the sorbo to correct AOE . Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.