How does one disassemble a Y&P M9??

[hawkite]

For some reason the trigger on mine has gone wrong and I am trying to open it up but I have no idea how to get the slide off as it is NBB.

Thanks.

[Guest PT247]

apparently there is a tiny little pin at the back of the slide.

[hawkite]

I've heard that too, I have found the pin but it has only budged a mm or so after shoving a tiny screwdriver into it. I am currently trying to find something thin and strong enough for to use as a 'nail' so I can hammer it out. Hopefully it will work, no idea what I am gonna do about the actual problem as I don't know anything about it :/

[hawkite]

Just in case somebody else has this problem of not being able to open up their pistol I will just say some things and maybe add photos later if I can.

• The little pin is on the side of the slide near the back as said before, it is really difficult to get out (at least for me it was) I had to get a hammer and hit it out with quite a lot of force but then it slid out easy ish with pliers.
• There are a few really annoying springs around the cocking hammer (idk if that is what it is called) and the trigger.
• My problem was a snapped off part on a piece connected to the trigger so my pistol is completely broken unless superglue works, if not I am 3D printing another one haha.

[SeniorSpaz87]

The pin is likely a roll pin or a punch pin. Be careful with pliers; those pins are basically a flat sheet rolled into a tube - they are not sealed on the open end. If you crush them they can be a pain to replace.