Governor Posted October 10, 2010 Posted October 10, 2010 The other day i was shooting my gun at cans to do the (rough) FPS test and it started to smoke. I later looked at the gun and where you put in the battery the wire connected to the gun was a bit shriveled up and loked like it had been slightly melted, no wire was showing. Is there anyway i can prevent this from happening again? Thanks, Albert
baxter-panda Posted October 10, 2010 Posted October 10, 2010 has the fuse blown just sounds like the wires got hot and melted, due to the poor make, the fuse should blow to stop this, but i would recomend strip it down, and replaced the electrics with a TM set, the electrics are so much better
Governor Posted October 10, 2010 Author Posted October 10, 2010 has the fuse blown just sounds like the wires got hot and melted, due to the poor make, the fuse should blow to stop this, but i would recomend strip it down, and replaced the electrics with a TM set, the electrics are so much better where can i get the tm wires from and would it be easy(ish) thanks, Albert
JerseyRider Posted October 11, 2010 Posted October 11, 2010 TBH if you start buying TM parts its going to end up costing you more then its worth
Governor Posted October 11, 2010 Author Posted October 11, 2010 TBH if you start buying TM parts its going to end up costing you more then its worth Thanks, should i just buy something like a SRC M4A1?
Recommended Posts
Archived
This topic is now archived and is closed to further replies.