MZKaleem Posted September 9, 2012 Share Posted September 9, 2012 Okay guys, so I currently use a KWA/KSC/ASG Glock 19 as my sidearm. This gun most likely uses System 7/NS2, correct? It has a metal slide, but it uses too much gas, would purchasing a plastic slide and barrel (Or just the slide) make it more gas efficient? Sorry, as you may have read next to the title, Two years of airsofting hasn't got me as far as I'd hoped in the way of Gas guns -Zak Link to comment Share on other sites More sharing options...
Supporters TPI Posted September 9, 2012 Supporters Share Posted September 9, 2012 How Many Mag's do you get from one Fill? i ask because i get 3 and i'm furthest north Link to comment Share on other sites More sharing options...
MZKaleem Posted September 9, 2012 Author Share Posted September 9, 2012 Lol, I get only 1, maybe 2 if im lucky, last time i tried was about 20 degrees. Not too cold. Maybe I got dodgy mags or gun. It could also be because the slide got stuck at one point and the shop owner hit the gun on the table to fix it (which worked). but i dont think that would cause it? Link to comment Share on other sites More sharing options...
MZKaleem Posted September 10, 2012 Author Share Posted September 10, 2012 Don't worry I got it sorted. I usually use a lower powered gas rather than green gas. I'll start using GG from now on. Thanks anyway. silly me! Link to comment Share on other sites More sharing options...
Supporters TPI Posted September 10, 2012 Supporters Share Posted September 10, 2012 I forgot about this yea i use green gas myself usualy the stuff AW Sell i'll go get a Link Link to comment Share on other sites More sharing options...
MZKaleem Posted September 16, 2012 Author Share Posted September 16, 2012 http://www.airsoftworld.net/bb-s-and-other...n-gas-250g.html this the stuff you were talking about? Link to comment Share on other sites More sharing options...
Supporters TPI Posted September 16, 2012 Supporters Share Posted September 16, 2012 oop's forgot about it again.. yea it is Link to comment Share on other sites More sharing options...
ginger colin Posted February 23, 2013 Share Posted February 23, 2013 Are you venting too much. See if you can work out where it is coming from Usually it will vent at the eject port..... If you are loosing a lot at the port try standing a mag upside down in a drop of abbey silicon spray over night. This is an easy way of gauging you tolerance on the seal fit. Your mags may need new seals. If you are venting at the rear (no pun) its usually the shuttle seal (dont know real name) There is a little valve that goes back and forth in the piston. Wear or dirt is common in most guns. http://www.airsoftforum.com/board/UPGRADE-KWA-KSC-GLOCK-t187947.html Check part 27 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.