Small M14 Project - help needed

[Karnus]

Hey - I saw this M14:

I love it, and want to replicate it. The only problem is I can't see how the silencer goes right up against the body. The faux gas block is also another issue I can't figure out.

Any help would be appreciated in copying this beautiful rifle.

The silencer on it is a madbull quicksilver in matte black.

Thanks in advance

 

[M_P]

id assume, a lot of cutting down the barrel and other parts at the front and then tapping a thread on the end for the supressor

 

[REMSoft]

Perhaps you should ask the guy who originally made it? I assume you got that from the DMR thread on Zero in?

 

[Karnus]

That's right yes. I did message him a few days ago but I have had no reply yet.

I've asked on the zero in forum but haven't had much luck so I thought i would try a different community

I do hope there is a way around it without resorting to hacking bits off

 

[M_P]

I doubt it, judging by the shape of m14's you'll have to do a fair few mods

 

[Karnus]

I doubt it, judging by the shape of m14's you'll have to do a fair few mods

I'll take my m14 to bits when I get in and see what can be done. How would one "tap a thread" if I cut down the barrel?

Thinking about doing it to my beloved M14 doesn't bode well at all can't make omelette without cracking eggs I suppose...

 

[Rock-climby-Dave]

If you aren't sure what 'tapping a thread' means at this stage - give it to someone with far more experience.

The tools to tap a 14mmCCW thread are expensive and rare.

 

[SpecialForce]

If you aren't sure what 'tapping a thread' means at this stage - give it to someone with far more experience.
The tools to tap a 14mmCCW thread are expensive and rare.

Hi I found a company who can order 14mm ccw thread cutter, with 2mm, 1.5mm or 0.50 pitch. Do you guys think it would be worth getting that?

My new partner runs a airsoft upgrade and repair service.

rb