bodykit and allen screws

Did the camo shell come with its own set of screws? If so, my below questions are relevant to that:

Was they easy to remove initially?
With both parts of the shell off and empty, do the screws go back in properly and at the correct points?

If yes to the above, have you tried putting your internal back in and started putting the bolts/screws from the back?

You’ve not really given anybody any information to help you, other than a few pictures and some vague details.
 
And this is why you usually don't mix and match (external) parts from different brands.

Unfortunately, apart from M4s, most guns have somewhat proprietary externals and in some cases they have proprietary internals to fit those proprietary externals. Your P90 might be just the case
 
Did the camo shell come with its own set of screws? If so, my below questions are relevant to that:

nope. just the shell in 2 halves.

Was they easy to remove initially? 10 x easier than the new camo shell


With both parts of the shell off and empty, do the screws go back in properly and at the correct points?

swapped original body over to the new one.

the 5 removable screws/ bolts from the original are in the same place on the new shell.

i think im going to remove the gearbox and glue along the crease in the final 1/3

gun fires fine except in semi where i believe the movement at the back and slight move of gearbox causes a bit of misfiring.

if not. ill buy a new higher quaility and swap

thanks all
 
You must log in or register to reply here.
Back
Top