nvasilei

@Dan Robinson Thanks for the info! Not a word about the ICS 😅

@Dan Robinson Do you have a list of mags that work with your Specna that you could share? Which model do you have? Thanks for the warm welcme 😂😂😂

Thanks everyone for your answers! I have checked that my hop up unit can move about 1-2 mm forward if I push on it. I have tried holding the mag at different positions and see which works best. It seems that I get less jams (after 10-15 BBs instead of 2-3) when the mag is fully pushed forward. I've wrapped the mag with electrical tape so that it sits more snug inside the magwell. Also when the RIF stops firing shaking it a little seems to unjam it every time (with or without tape on the mag). Comparing the battleaxe mid-cap (which is not feeding properly) and my specna arms high cap it seems that the feed tube on the battleaxe mag sits about 1 mm proud. Does it make sense to file it down and get them to match? Also just to mention that I have tried some of the mags that misfeed in my RIF on my friend's RIF (same model, we actually ordered them together) and they seem to work fine (at least for much longer that mine) but could be due to different tolerances between the two . I will have to check all the mags that I have problems with on his RIF to make sure. I've also attached a picture of the magwell maybe you can spot something wrong with it and the two mags in question (on left is the battleaxe one and on the right is specna arms). Thanks again!

Hi everyone, New guy here, I've recently bought my first RIF a Specna Arms C07 and have only used it for about 5-6 hours. It works perfectly with the high cap mag that it came with but when I try different mags (evolution high-cap, battleaxe mid-cap) it has feeding issues. More specifically it will fire a couple of BBs and then stop firing (pulling the trigger cycles the gun but no BBs come out of the barrel). When I pull the mag out about 4-5 BBs drop out and if I fire again (without a mag in) a single BB comes out the barrel. Are there any tests I can perform to identify the issue or a fix that I could try? Thanks!