steverebo

Ok scrap that the Prometheus purple bucking and nub do not work nicely with my specna arms sa 07 edge 1.0 as I lost over 10fps Any suggestions on ones that might be a good fit

So I have purchases a Prometheus purple hop rubber. Amd it does jot have a good air seal so my fps drops and is inconsistent Any suggestions on one that fits the specna arms sa-07 edge

I need to find a place to source some more ideas. I am going to print some hex rail covers but after that I'm out of ideas

Finally got it all together with my 3d printed parts. 3d printed mag well 3d printed foregrip 3d printed tac torch mount 3d printed wall mount and MAG rack all in petg I have swapped out the stock barrel and bucking for a ZCI 6.02 294mm barrel and Prometheus purple bucking and nub and a ZCI high torque motor Now it's nice and snappy and very accurate

Cheers guys you have all been a great help I've gone and purchased a zci 6.02 294mm barrel and Prometheus purple bucking and nub and I have 3d printed a much nicer foregrip and a magwell in petg that both look lovely currently printing a holder for my surefire torch (I didn't buy it it was issued to me as a recruit many years back) and I've got a dual mag holder and some keymod covers ready to print Also where can I grab a cheap chrono? I have a cr6 se printer 235 x 235 print bed I print pla and petg

Brill I feel really need to waste money on something for this gun so I will grab the speed loader and MAG mags. Yes I do do commmissions on the side to fund the cost of my filaments and printer bits. Didn't realise till now how much can be printed for airsoft

Cheers guys for the advice maybe a bone yard gun after a few months of playing will tickle that tinkering itch, what speed loader and mid cap mags would you guys recommend? Just grabbed a red dot sight and owning a 3d printer has some advantages as I have printed a nicer fore grip and a mag well is on the print bed now

Very true and your right despite all the vids and articles I have read I don't have a clue about the sport yet just very excited and want to buy new things for my new toy and make it my own. Any recommendations on what I could buy for it that does not involve playing with the gearbox for now? I did grab a nuprol 11.1v 30c battery and smart charger

Yes I know, I know touching it straight away is silly. I Will obviously have a play with it first but having seen every video showing the orion gearbox and the lack of grease and some qc issues that need cleaning up being a bit of a tinkerer (custom watercooling/3d printing) I'm not too scared of ha ing a play What barrel would you recommend?

So I mentioned that I wanted to start doing airsoft so my wide treated me to a specna arms 07 edge. I have read a lot of stuff and watched a lot of videos and the concesus was I been to open it and Check its all OK give a good lube a d remove any rough bits so whilst in there I think I might replace a few bits but being new I wondered if I could have a bit of guidance. I was looking ate going with the below: Rocket SHS 13:1 OR Rocket SHS 16:1 GEARS SHS high torque 16tpa motor J-caged 8mm bearings Prometheus purple hop rubber BP customs m4 timer trigger Replacement o-rings How does all this sound and will it work?

I'm going 13:1 gears with a 16tpa high torque motor and don't want to start removing teeth ect to stop overshoot and active breaking appears to be the best way

I have a specna arms e07 edge and want to add active breaking with the nano aab. I have looked at the manual and it appears that I can just swap them out as the sa e07 has the 2 live wires on one trigger contact and the single signal wire on the second as described in the nano aab installation. I just want to confirm this is right