RAM

Hi I have a Wolverine MTW with a inferno gen 2 engine. Long story cut extremely short the Spartan board is dead so I purchased a Gorilla FCU to replace the Spartan and I am wondering if anyone here has done the same and might be able to help me with the settings. I am a total newb when it comes to HPA so any help with setting up the FCU would be greatly appreciated.

Well I just checked it and it all looks fine to me. But on a good note I figured out how to get the mags to load without pressing the mag release button. I have to twist the mags slightly for them to slide home. Now I just have to wait for the new nozzle and cylinder head to hope I it solves the low FPS as I don't want to have to buy a new inner barrel to get it back to stock length.

I thought it was metal i will double check tomorrow. Thanks for the pictures.

Just had a look at the parts diagram and it looks like the mag release is stock.

Hi the gun is not new it is used. I tried tipping the mags forward as I was loading them and backwards nothing seems to allow them to lock home unless I press the mag release slightly, It only needs to be pressed about 1mm for it to allow the mags to then slip into place, Every mag looks OK to me with now signs of damage or wear. The mag catch looks standard to me but having never owned a Vector before I can't be 100% sure. I have tried to get some pictures to help with this.

Sorry I think my explanation might be misleading. I cant get the mags to lock into the magwell unless I press the mag release as where on my other AEG'S which are M4 platforms I can just push the mags into the magwell and they click into place and lock without having to press the mag release button. Hope this makes a bit more sense.

Hi I just purchased a Krytac kriss vector and I have to press the mag release to get the mag to load. Is this normal or do I need to check that something is not binding up ?

Thanks for the idea I did itand it created a small gap to let me see that there was a plate around the back and figure out how to do it which it use a flat head screwdriver and gently lever it forward from the receiver. It was binding on the mock gas tube. Added a photo for reference just incase anyone else has this issue.

Hi can anyone help me with solving how to remove the handguard from the Specna Arms SA-V38 (Sailent Arms GRY). I have looked for screws around the outside but can't find any and I have also pulled the pin at the bottom and lifted the catch in the hope that is how you get it off like on the real version but it doesn't want to budge and I don't want to break it. The reason I want to remove the handguard is so I can clean the outter barrel before having a go at painting the rifle. If anyone knows how to remove the handguard I would very much appreciate the info on how to do it.