Sign in to follow this  
Followers 0
baxter-panda

You will fit

11 posts in this topic

not really,

 

iv just had to spend £120 on bits to upgrade my gearbox, it did not like it after 300 rounds lol

Share this post


Link to post
Share on other sites
i got it from the aims fair today, as it was

 

10v, 4200Mha £25 :)

 

 

sure its not a 10.8 ??

Share this post


Link to post
Share on other sites
sure its not a 10.8 ??

 

its close enough, not bothered about the point of a volt

 

 

Bye Bye gears :)

its all ready broken, the head come off the motor, ripped the plastic piston to bits lol

 

iv allready got a gearbox comming stuck in customs, just orded a new fully steel piston, high speed gears

Share this post


Link to post
Share on other sites

Thats a great ROF mate built a few like that myself, a small suggestion if i may, I notice you are fitting a steel piston and full gearset. The problem with massive rate of fire is that if something does go wrong it can mess everything else up inside the gearbox fast.....lol and boy can that get expensive.

 

What I tend to do is deliberately leave a weak link in the mechanisum, normally for me the piston. This point of failure needs to be a cheaper component. that way when the gearbox gets to the point of wear to the point of failure it's the less expensive bit that fails not the whole lot.

 

Good job Mate, and watch out for the overkill mate, it's far to easy with that sort of ROF

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0