BlackFox888 Posted yesterday at 11:24 Share Posted yesterday at 11:24 Hello everyone. I recently bought a T238 Active Break mosfet, I did quite a bit of modding before, but this is my first time wiring a mosfet. I hooked up everything according to the schematics, but when the trigger is pulled, the motor doesn't spin at all. Did I wire up something improperly? What could be the issue? Excuse my bad soldering, I also didn't use shrink tubes for now, in case I mess something up. Images and the wiring scheme is attached below. Thanks for any help. Link to comment Share on other sites More sharing options...
Supporters Lozart Posted yesterday at 15:58 Supporters Share Posted yesterday at 15:58 I think the issue may be your soldering. The red wire through the centre(ish) of the board looks like a very dry joint, as do the connections on the battery connector. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now