Jump to content

Archived

This topic is now archived and is closed to further replies.

PhillipR34

Rail systems

This thread is over three months old. Please be sure that your post is appropriate as it will revive this otherwise old (and probably forgotten) thread.

Recommended Posts

I've been looking at getting a free float rail system for my G&P M4A1. My gun is front wired and I want to get a PEQ box but I've been wondering what happens to the wires? Do they have to be cut or are they out of the way when I remove the delta ring and the part that screws in the receiver?

Share this post


Link to post
Share on other sites

what I did was to get the fuse holder in under outer barrel then remove the battery plug then poke though one of the holes near to where I was mounting PEQ box reconnect plug small hole in back of PEQ box job done. Was a tad bit fiddley with fuse housing but got there in the end. Saying that just replaced it for a rear wired g/box

Share this post


Link to post
Share on other sites

×
×
  • Create New...