Lipo charging help

[Lokai]

Evening all, looking for some noob assistance please.

So, got my first lipo battery this week along with what I thought was a decent charger to go with it. 

First problem, the charger didn't come with the right cable. So off to Amazon I went and bought a multi connector banana cable.

Decided to get it charged today so I could play with my new rifle.

When connecting the battery to the cable red was going to black , I thought it was supposed to be red to red, black to black. As soon as I connected the charger flashed up reverse polarity so I quickly unplugged and haven't dared try again since!!!!! 

A few pics below to show what I mean. Any advice? Dying to try new gun  but don't want to burn the house down (may have read too many horror stories about lipo's blowing up etc)!!

thanks for the help.

View attachment 36161

View attachment 36160

View attachment 36159

View attachment 36158

 

[Lokai]

These are the ports -

View attachment 36165

 

[E21A]

You need to charge it on the balance lead, NOT the Tamiya connector 

 

[Lokai]

You need to charge it on the balance lead, NOT the Tamiya connector 

Thanks, I did initially try this but I just get a "connect error check main port" message flashing up.

 

[Chris_B]

Swap the banana style leads over that goes into the charger and plug in the white balance lead connector... simples

 

[Lokai]

Swap the banana style leads over that goes into the charger and plug in the white balance lead connector... simples

Why didn't i think of that!!! Lipo is now balance charging as we speak!!! Thanks for the help.

 

[Sitting Duck]

Amazon leads are often ar$e about face polarity cheapo china converters

Part of reason is coz on small tamiya RED is Round connector & BLACK is Square

BUT

on Large taimya (ye olde guns and RC stuff), BLACK is Round & RED is Square

so the two tamiya type connectors have different polarity/pinouts

then add in cheapo fleabay/Amazon/China plugs and you end up with a 50/50 lottery

very often the fleabay ones are wrong polarity for airsoft peew peew

grab a pin/needle, push it down the unplugged converter, releasing the connectors

then swap them over to correct polarity - simples - 5 min job if that

if you had bought the converter from a reputable place like component shop it would have been correct

once you get the hang of soldering you will probably go deans on most guns

then make up your own leads/converters if need be from old bits of wiring loom