Szelwa

Hi all. I hope someone will be able to share some ideas how to fix my problem. I just finished fitting mancraft v3 into the Specna Arms G36 (same as ares). Took me some time with dremel to make it fit into gearbox as original mancraft v3 gearbox would not fit at all in the gun. Trouble I have is that rif is feeding 2 bbs at the time. I adjusted and tested length of the original nozzle than swap for the 24.5mm one dedicated for G36 for better air seal. Swapped hop up as well as tested 2 different mags hi cap and low cap TM. To no change. Worth to mention I had same problem on this one while it was aeg.

Ok folks following this I’d like to report that spring from hi cap mag on g36 does fit and does the job. All tested and shooting. How long will it last …? thanks for the tip.

I’ll have a look in an hour and report got g36 and m4 hi cap mags busted

Hi all Correct me if this should go to different topic group. In my WE gas drum the anti reverse spring gave up - see pic. Searched internet but only can see one place from HK offering replacements. Is anyone aware of replacement for this part of some technical name for this spring to be found outside Airsoft suppliers. I can’t believe that quite expensive part would be useless after lil spring gave up. and yes my mate was spinning it in wrong direction lol

Hi still having this problem? did you try playing with trigger adjustments? Most probably it’s one of the gears inside, those can wear off just from looking at them too long. One of AAP features. I’d suggest fitting new cow cow set and add auto sear as well for good measure.