CrumpsRAWR

Hm, think I'd rather stick with electric if I'm honest - good for all weathers! Thanks for the tips though Loz, I'll look into that stuff.

Title says it all, I have a mosfet coming which is to be hard wired, and I know a high torque motor of some sort is required? But is there any way to get the trigger response while keeping a high speed? If not, what do I need to do to achieve? Thanks.

Okay buddy, I'll give it a slam later - Will it weaken or loosen the paint already on parts? (Not factory paint)

Some of them are engraved deep enough to keep, however some of them are only slightly engraved and spray covers them.

Diet coke you say? I'll grab a couple bottles and bathe it - should I seal it within a container or is it fine in open air?

Buggar, was hoping to keep the original markings intact.

Hi Loz, it isn't tacky to the touch no - but the once black paint underneath now has a weird haze over it, maybe it needs a full acetone bathe to clean it down properly.

Hello there! I recently bought a G+P Sentry, which came with an awful desert camo paint job already applied. I've used plenty of Acetone to remove the paint from the full metal body, however some of it just will not lift and it's left the body with a tacky almost dirty look which chemical cleaner or the good ol' fairy liquid just will not lift. So I'm crying out for help, I've almost for it back to beauty I just need advice on how to get it looking clean and fresh! Thanks to any and all information.

Thanks for the link, looks like a very solid gun. Has anyone had one who could give me a quick review?

Hello! The chap I'm buying from is selling a G&G CM16 M4, Has a Madbull tightbore and Daniel rail, 2 mags, battery and charger included and is looking for £200 postage included. I mainly play at a CQB site, which has a 350 cap on AEG's, this little fella is only running at 250, how much will it affect me? Will it reduce the range a lot, or the power at range? I don't know a lot, so looking for solid advice. Thanks to any and all replies.