Cybergun Thompson

[Cooperman26]

My god! Stress levels 100000x

 

fitted the wood kit, a few amendments needed not an issue. Plug her in, ran a few mags no issues.

 

Then just went dead. 
 

Took her apart, checked the fuse, checked the connections, no issues, took the motor out where it sits plugged in, Pew pew!

 

Awesome! Screwed motor back into place, attached battery, NOTHING. Took the motor back out, tested again, ABSOLUTELY FINE. Put it back in position, DEAD. Did this numerous times. 
 

Am I missing something blindingly obvious!?

Edited 10 hours ago by Cooperman26

[Austeyr]

From what I remember (Cyma/Cybergun same pew?) I had to shim my Cyma Thompson screw as it was able to be tightened too much to the point it wouldn’t fire but if it was loose the grip was also loose.

The same happened on the dodgy KA one I bought off of here a while back, to the point there was at least half a centimetre gap from receiver to pistol grip to get it to work.

 

Not a guarantee it’s the same issue, obviously, but that was my issue so maybe the same for you?

[Cooperman26]

Morning sir!

 

I shall have a look! Thankyou for an option

[Cooperman26]

No joy. 
 

when it’s out on its own no issue works. as soon as I attached it into the grip position nothing. I cant see any wires broken or anything 

Edited 1 hour ago by Cooperman26

[EDcase]

That indicates there is a short in the body.

Do you have a multimeter? 

If so check continuity between the body and each motor wire.

 

 

Edited 6 minutes ago by EDcase

[Cooperman26]

3 minutes ago, EDcase said:

Sounds like a short in the body.

Do you have a multimeter? 

If so check continuity between the body and each motor wire.

 

 

I don’t 😭

 

it’s now working when in the pistol grip position. But as soon as I screw it in half way it again stops. Won’t lie, it’s giving me a headache 🤕 

[EDcase]

Hmm, that IS strange. 

What do you mean, 'screw it in half way'?

 

What about if you pull it out slightly so the screw holes don't line up?