Loadout advice (belt mostly)

[Punisher3990]

Good morning all,

 

So, I am new to airsoft and have been slowly buying my gear. I have been getter cheaper stuff as per advice given. Mostly VIPER or KOMBAT stuff. 

 

Here's a pic of me in most of it

 

 

so my reason for the post is the belt mainly. I went for this Viper battle belt as it does a good job of hiding/keeping the belly in (lol) but I notice that most people use a belt with the velco inner. 

 

Would I be better off using one of those and then just having a hanging piece where the belt currently is? Or is my current load out good? 

 

Also any tips on my gear? is it decent? (I have lowered the PC after this image as I realised it was a bit high)(the belt also now has a holster, pistol mags and a couple.of rifle mags on it, it isnt just empty lol)

Edited 3 hours ago by Punisher3990
Spelling

[Lyndication]

Why's the belt on backwards?

[Punisher3990]

28 minutes ago, Lyndication said:

Why's the belt on backwards?

If its around the other way none of the molle is accessible so I assumed this is the way its meant to go since the connectors line up with the straps under the mag holders perfectly. 

 

 

Edited 1 hour ago by Punisher3990

[Lyndication]

9 minutes ago, Punisher3990 said:

If its around the other way none of the molle is accessible so I assumed this is the way its meant to go since the connectors line up with the straps under the mag holders perfectly. 

 

The wide bit goes at the back, those connectors are for if you're running a shoulder harness. (Like the ol' PLCE).

 

You don't to fill the front of a belt, it gets in the way of crouching and going prone. That wide bit lets you attach larger pouches for heavier stuff, like water bottles, gas bottles, and HPA tanks.

Oh and note on fitting the plate carrier. 

 

The top of it should be in line with your collarbone. The bottom will end up slightly below your ribs, ideally. The idea is to cover your ribcage cos that's where your most important squishy bits are.

[Enid_Puceflange]

You do whatever is most comfortable for you bud!
 

I think the clips on the bottom front of your plate carrier are probably for a dangler pouch, to carry more stuff in (and a bit of tummy protection)

 

I used to use one of those belts, to hold a dump pouch and an extra mag pouch or two, but wore it with the buckle to the front with a harness to support it over my shoulders.

 

I’ve moved over to one of the two part belts, and have found it far nicer to have moved a bit of weight to my hips, (they are very rigid and have little to no “sagging” or drop when you fit them properly) and not my upper where the weight is supported by my shoulders and then my back, allowing me to lighten my PC a touch (helping reduce back pain)

 

 

 

 

Edited 1 hour ago by Enid_Puceflange